Answer:
In the View tab, you will find Zoom Option. Set the Zoom level to 100%.
Explanation:
You need to set the Zoom level to 100%, And you can do this, by setting the zoom level to 100%, from the scroll bar. Or you can move to view tab in the main menu, and then in the Ribbon, you need to select the zoom % and set it to 100 percent. You will then be able to see the entire page. And if you want, you can increase the Zoom level to even further, for getting an even more clearer picture.
A partial dependency exists.
We have two types of dependency. The partial dependency and the transitive dependency.
The answer here is partial dependency. It occurs when the attribute only depends on some parts of the element. In such attribute, the primary key is the determinant.
It can be shown as;
XY→WZ , X→W and XY is the primary key or the only candidate key
Read more at brainly.com/question/9588869?referrer=searchResults
A Deceleration device.
A rope, wire rope, or strap with connectors at each end for connecting the 5 point body harness to a lifeline, or anchorage.
Look under OSHA Flashcards on Quizlet and..
OSHA: Fall Protection in Construction, Subpart M and just past that area in the document.
This is from that document on page 13 and 14:
Fall Restraint Systems: While fall restraint systems are not
mentioned in Subpart M, OSHA
recognizes a fall restraint system as
a means of prevention. The system,
if properly used, tethers a worker
in a manner that will not allow a
fall of any distance. This system is
comprised of a body belt or body
harness, an anchorage, connectors,
and other necessary equipment.
Other components typically include
Photo: Skip Pennington
OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION
1 4
a lanyard, a lifeline, and other devices. For a restraint system
to work, the anchorage must be strong enough to prevent the
worker from moving past the point where the system is fully
extended, including an appropriate safety factor.
*In a November 2, 1995 interpretation letter to Mr. Dennis
Gilmore, OSHA suggested that, at a minimum, a fall restraint
system must have the capacity to withstand at least 3,000
pounds or twice the maximum expected force that is needed
to restrain the person from exposure to the fall hazard. In
determining this force, consideration should be given to
site-specific factors such as the force generated by a person
(including his/her tools, equipment, and materials) walking,
slipping, tripping, leaning, or sliding along the work surface.
Hello <span>Rouahidy7821
</span><span>
Answer: When summarizing graphs of categorical data, report the models and describe the </span><span>variability.
</span>
Hope this helps
-Chris
