Answer:
One sheave means that you are using a single drum winder. They are the worst! Double drum winders control easier, brake better and are much more efficient. They save time ( two skips or cages) and can be clutched to perform faster shift transport. A single drum is slow, unbalanced and can be a nightmare if it trips out during hoisting. If the brake system is not perfect it can be a real hairy experience. For a runaway single drum, there is no counterbalance effect. It always runs to destruction. With a double drum, the driver still has a chance to control the winder to a certain extent and he has two sets of brakes to rely on. A single sheave could also mean a shaft with a single compartment. No second means of escape unless there are ladders or stairways. Not a very healthy situation.
Those are just a few points. I am sure much more can be said in favor of a double drum winder and two or more sheaves in the headgear. Most of the shafts I have worked at have multiple winders and up to ten compartments. They all have a small single drum service winder for emergencies and moves of personnel during shift times. They are referred to as the Mary - Annes. Apparently, the name originated in the U.K. where an aristocratic mine owner named the first such winder after his mistress.
Explanation:
<em>Hope you got it </em>
<em>If you have any question just ask me</em>
<em>If you think this is the best answer please mark me as BRAINLIEST</em>
Answer:
1 35
Explanation:
* There is a little typo in printf. It should be "\n".
Initially, the value of the first is 1, and the value of the second is 2. Then, do_something(&second, first) is called. The value of the <em>first</em> will still be 1. However, there is a call by reference for <em>second </em>variable. That means the change made by the function <em>do_something</em> will affect the value of the <em>second</em> variable.
When you look at the calculation inside the <em>do_something</em> function, you may see that value of the <em>second</em> will be 35.
The chart with the circle in the top right is a pie chart
the top left chart on enrollment is a histogram
the bottom chart is a bar chart
Answer:
False
Explanation:
There are also hackers online
The term that describes the IP address of a router to which packets destined for a remote network should be sent by default is the a gateway of last resort.
<h3>What is 'Gateway Of Last Resort'? </h3>
A Gateway of Last Resort is known to be the Default gateway and this is said to be a route that is known to be often used by the router if no other known route is seen to transmit the IP packet.
Note that Known routes are seen in the routing table. but, any route not known by the routing table is said or known to be forwarded to the default route.
Hence the primary function of a router is so that it can forward packets toward a given destination.
Therefore, The term that describes the IP address of a router to which packets destined for a remote network should be sent by default is the a gateway of last resort.
Learn more about IP address from
brainly.com/question/24930846
#SPJ1
