While( n ) /*when n == 0, will fail*/
{
putchar( '*' ); /*effectively print asterick*/
n--; /*post-decrement n*/
}
Answer:
yes it can communicate with all interfaces on the router.
Explanation:
PC1 has the right default gateway and is using the link-local address on R1. All connected networks are on the routing table.
Netsh may be a Windows command wont to display and modify the network configuration of a currently running local or remote computer. These activities will tell you in how manny ways we can use the netsh command to configure IPv6 settings.
To use this command :
1. Open prompt .
2. Use ipconfig to display IP address information. Observe the output whether IPv6 is enabled, you ought to see one or more IPv6 addresses. A typical Windows 7 computer features a Link-local IPv6 Address, an ISATAP tunnel adapter with media disconnected, and a Teredo tunnel adapter. Link-local addresses begin with fe80::/10. ISATAP addresses are specific link-local addresses.
3. Type netsh interface ipv6 show interfaces and press Enter. note the output listing the interfaces on which IPv6 is enabled. Note that each one netsh parameters could also be abbreviated, as long because the abbreviation may be a unique parameter. netsh interface ipv6 show interfaces could also be entered as netsh ipv6 sh i.
4. Type netsh interface ipv6 show addresses Observe the results of the interface IPv6 addresses.
5. Type netsh interface ipv6 show destinationcache and press Enter. Observe the output of recent IPv6 destinations.
6. Type netsh interface ipv6 show dnsservers and press Enter. Observe the results listing IPv6 DNS server settings.
7. Type netsh interface ipv6 show neighbors and press Enter. Observe the results listing IPv6 neighbors. this is often almost like the IPv4 ARP cache.
8. Type netsh interface ipv6 show route and press Enter. Observe the results listing IPv6 route information.
Answer:
a point at which the user chooses a certain path.
Answer: ....
Dust and debris can cause performance deterioration.
Explanation:
Dust is a problem from the standpoint of blocking fan vents, or, if deep enough, actually insulating parts, causing overheating, but unless it contains substantial amounts of corrosive or conductive material (in which case you shouldn’t be breathing it), it won’t damage the electrical components (beyond any overheating damage).
What could happen, in some circumstances, is condensation inside the box, mixing with dust and creating a conductive sludge. This would generally only occur if you bring the box in from an extremely cold environment (below 0C, roughly) into a humid indoor environment. The protection from this is to wrap the box tightly in plastic before bringing it indoors, and leave it wrapped for a couple of hours, while it has time to warm up.
