Answer:
d.
24 to 32
Explanation:
Satellite programmers broadcast, signals to the satellite which they own or lease the channel space from. Uplinked signals sent by the programmers are received by the transponder located on satellite. It is a device which receives signals and transmits them back to Earth after converting the signals to frequency which could be received by the ground-based antenna. <u>There are typically 24 to 32 transponders on a satellite. </u>
You would place it in orbit around Earth, as most X-rays are absorbed by the atmosphere, so you would want the detector outside of the atmosphere to accurately detect the X-rays.
The following options helps keep people from slipping on floors
A) Have the proper absorbents in an easy-to-find place to quickly put on spills : So that accidental little spills can be cleaned right away.
C) Wear slip-resistant footwear : It is a precautionary step to follow, no matter where we go.
D) Mark a slippery area with an easy-to-use tent sign that says " Caution, Slippery floor" : This allows people to be aware of the wet area and cross it cautiously.
Leaving oil and fluids to air dry thoroughly, takes a long time and there are chances that people step over it and slip.
So, the answer is
(B) Anytime oil or fluids are spilled on the floor, leave them to thoroughly air dry.
Answer:
yes I agree with you
Explanation:
I have been keyboarding for the past 7 hours.
Answer:
In C++:
int PrintInBinary(int num){
if (num == 0)
return 0;
else
return (num % 2 + 10 * PrintInBinary(num / 2));
}
Explanation:
This defines the PrintInBinary function
int PrintInBinary(int num){
This returns 0 is num is 0 or num has been reduced to 0
<em> if (num == 0) </em>
<em> return 0; </em>
If otherwise, see below for further explanation
<em> else
</em>
<em> return (num % 2 + 10 * PrintInBinary(num / 2));
</em>
}
----------------------------------------------------------------------------------------
num % 2 + 10 * PrintInBinary(num / 2)
The above can be split into:
num % 2 and + 10 * PrintInBinary(num / 2)
Assume num is 35.
num % 2 = 1
10 * PrintInBinary(num / 2) => 10 * PrintInBinary(17)
17 will be passed to the function (recursively).
This process will continue until num is 0
