Answer:
UT
Step-by-step explanation:
The projection of ST on QT is found by locating the points on QT that are nearest the endpoints S and T of the original segment. On QT, U is the point closest to S, and T is the point closest to T. Then the projection is the segment between those identified points: UT.
Answer:
it has a lower mass/volume ratio
Step-by-step explanation:
Density is the ratio of mass to volume. An elevator will have the same volume, regardless of the number of people. The mass will increase with the number of people.
An elevator with 50 people in it will have a higher mass/volume ratio than an elevator with 3 people in it. Hence the latter is less dense.
__
<em>Additional comment</em>
50 persons would require an industrial elevator of perhaps 10,000 pound load capacity. There might be safety issues with carrying that many people.
Answer:
I need a picture and more information to help :)
Step-by-step explanation:
8x-5 would be the largest angle because as you approach a larger and larger x value, 8x-5 will skyrocket past the other two. Also when you plug in a low value like 1, 8x-5=3, which is still higher than the other two. The only exception is if you plug in a negative x value which is impossible.
8x-5
