Answer:
22
Step-by-step explanation:
Range-find the largest number and subtract the smallest number from it
96-74
Answer: Kara should have written the proportion in step 1 as;
Start Fraction 12 Over 72 End Fraction = Start Fraction 14 Over x End Fraction (that is 12/72 = 14/x)
Step-by-step explanation: The two similar triangles are given with the following dimensions;
Triangle VXW with side VW = 12 and side VX = 14. Also Triangle ZXY with side YZ = 72 and side XZ = x.
For two triangles to be similar, then there must be a similarity ration that is consistent with all sides in both triangles. This means if in the first triangle a side measures 1 unit and the similar side in the other triangle measures 5 units, then the ratio of similarity of corresponding sides shall be ratio 1 : 5. So for every corresponding side in the second triangle the measurement shall be times five of the side that corresponds in the first triangle.
Therefore, in triangle VXW and triangle ZXY, the corresponding sides are as follows;
VX = ZX
VW = ZY
XW = XY
What Kara did was as follows;
VX/ZY = VW/ZX
Which translates to 14/72 = 12/x
This was a wrong calculation because the side that corresponds to VX is ZX and not ZY.
The correct step should therefore have been;
VW/ZY = VX/ZX
12/72 = 14/x (Step 1)
12x = (72) (14) {Step 2}
x = 1008/12 (Step 3)
x = 84 (Step 4)
Answer:
Not quite sure what you're meant to solve for, but my solution is below.
Step-by-step explanation:
The square root of a value squared is the absolute value of that value, because squaring removes all negatives. Therefore:
Hope this helps!
Answer:
Exfoliation
Step-by-step explanation:
Changes in temperature cause rock to expand (with heat) and contract (with cold). As this happens over and over again, the structure of the rock weakens. Over time, it crumbles.
Rocky desert landscapes are particularly vulnerable to thermal stress. The outer layer of desert rocks undergo repeated stress as the temperature changes from day to night. Eventually, outer layers flake off in thin sheets, a process called exfoliation.
For angles in first quadrant, the reference angle is itself. In second quadrant, the equation would be 180 - x where x is the measure of the angle. In third quadrant, x - 180. Lastly, in the fourth quadrant, the reference angle is 360 - x. From the second set of angles in the given, the reference angles are.
(1) 135 ; RA = 180 - 135 = 45
(2) 240; RA = 240 - 180 = 60
(3) 270; RA = 90 (lies in the y - axis)
(4) 330; RA = 360 - 330 = 30
