Question

Some steps to construct an angle MNT congruent to angle PQR are listed below. Step 1: Draw a segment NT. Step 2: Use a compass to draw an arc from point Q that intersects the side PQ of angle PQR at point A and the side QR at point B. Step 3: Step 4: Adjust the width of the compass to AB, and draw an arc from point X such that it intersects the arc drawn from N in a point Y. Step 5: Join points N and Y using a straightedge. Which statement describes step 3 correctly? Use the same width of the compass to draw an arc from point T that intersects the segment NT at a point X.
Use the same width of the compass to draw an arc from point N that intersects the segment NT at a point X.
Use the same width of the compass to draw an arc from point A that intersects the segment NT at a point X.
Use the same width of the compass to draw an arc from point B that intersects the segment NT at a point X.

Answer 1

Answer:

Following are the solution to this question:

Explanation:

To create an MNT angle consistent with PQR angle:

Measures to build an MNT angle:

Step 1: Have used a compass and draw the arc through point Q which passes point With asides QR.

Step 2: Construct the NT section, and create an arc from position N, which crosses the NT section at point x, which uses the same chart width.

Step 3: Adjust the high compression to AB or create an arc in point X that intersects a prior arc in point Y, created by N.

Step 4: Using straightedges to connect points N and Y.

Step 5: Position MNT was its angle equivalent to a PQR angle.

Answer 2

Answer:

B took the exam got 100

Explanation: