Answer:
Crosstalk, Jitter, Impulse noise.
Explanation:
Crosstalk is a network error that occurs when one pair of cable causes interference on another pair of cables thereby preventing efficient data transmission.
Jitter may also impair the accuracy of the data being transmitted across network because minute variations in amplitude, phase, and frequency always occur. The generation of a perfect carrier signal in an analog circuit is almost impossible. The signal may be affected by continuous and rapid network gains or phase changes.
Impulse noise (also referred to as spikes) is the primary source of errors in data communications. Impulse noise can be caused by positioning a communications cable near a source of intermittent but strong electromagnetic pulses, such as an elevator motor.
Counter measures
Shielding (protecting wires by covering them with an insulating coating) is one of the best ways to prevent impulse noise, cross-talk.
Amplifiers can be used to increase signal strength since the connection would run across 4 floors.
Solution:
The flagging of an uncommon last name as a spelling error can be stopped by opening the shortcut menu on the first occurrence of the name and selecting of ignoring all.
Thus the required right answer is B.
Answer:
wear a mask use hand sanitizer dont get in contact with anyone between 6 feet
Explanation:
Answer:
From the two IP addresses, 192.168.2.1 can be listed as the default gateway in local network devices.
The reason is that we are allocated with the ranges that are reserved for the local networks by RFC 1918.
These ranges are given as follows:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Moreover the default gateway for a device can also be known by the commands ipconfig or ipconfig/all on the command prompt.
<h3>I hope it will help you!</h3>
Answer:
See attached file for complete detailed code.
Explanation:
See attached file.
