Answer:
Written in Python
name = input("Name: ")
wageHours = int(input("Hours: "))
regPay = float(input("Wages: "))
if wageHours >= 60:
->total = (wageHours - 60) * 2 * regPay + 20 * 1.5 * regPay + regPay * 40
else:
->total = wageHours * regPay
print(name)
print(wageHours)
print(regPay)
print(total)
Explanation:
The program is self-explanatory.
However,
On line 4, the program checks if wageHours is greater than 60.
If yes, the corresponding wage is calculated.
On line 6, if workHours is not up to 60, the total wages is calculated by multiplying workHours by regPay, since there's no provision for how to calculate total wages for hours less than 60
The required details is printed afterwards
Note that -> represents indentation
Answer:
The answer to this question is given below in the explanation section.
Explanation:
The correct answer to this question is d- 346px.
The complete code of this example is given below:
<div>
style="margin:20px; border:solid 3px #888888;">
</div>
while the image width is 300px.
It is noted that the image width is 300px and the margin is 20 px.
Margin:20px means that image margin from four side is 20 px each.
So the width of dive from both side increase to 40 px and the image has 300 px, then total width becomes 340px. Now the border also has 3px of four sides of the image, then the width of the border becomes 6px.
so the total width of the div tag is 346 px.
In short, we can calculate the width of tag as below:
total width of div= width of image+ width of margin+ width of border
total width of dive= 300px+40px+6px
total width of div=346px.
Cognitive surplus results when leisure time and available tools allow us to engage in creative acts. It is a term that was introduced by Clay Shirky which pertains to the synthesis of the excess of people's energy, time and creativity leading to productivity sharing and creation.
Answer:
FF-FF-FF-FF-FF-FF and 255.255.255.255
Explanation:
FF-FF-FF-FF-FF-FF can be defined as the layer 2 address broadcast which is often used on ethernet frames as well as help to broadcast all equipment due to the fact broadcast is made possible through Ethernet networks in which the Frames are addressed to reach every computer system on a given LAN segment as far as they are addressed to MAC address FF:FF:FF:FF:FF:FF.
255.255. 255.255 can be seen as the layer 3 address which help to address the exact same hosts because it enables the broadcast address of the zero network which is the local network due to the fact that the IP broadcasts are often used by BOOTP and DHCP clients to find and send requests to their respective servers in which a message sent to a broadcast address may be received by all network-attached hosts.
Therefore the Layer 2 and Layer 3 destination addresses which the message contain are FF-FF-FF-FF-FF-FF and 255.255.255.255
