The domain in an email message tells you the type of service provider.
Hope this helped! :)
A range check is often used when a person works with data consisting of numbers, dates and times, or currency, ensuring that a number is within a specific range.
Explanation:
- Range checks allow a person to set suitable boundaries.
- An example of a range check is checking to see if the value of a 16-bit integer is within the capacity of a 16-bit integer. When a range check is performed, upper and lower boundaries are specified.
- Range check is a validation check which can be applied to numeric fields. This is done to ensure that only numbers within a certain domain can be entered into a field. Remember that this does not necessarily mean that the data entered will be correct. But it will certainly lie within reasonable limits.
- A method of validation which checks that data falls between an upper and lower acceptable value.
- This validation check which can be applied to numeric fields. This is done to ensure that only numbers within a certain domain can be entered into a field. Remember that this does not necessarily mean that the data entered will be correct. But it will certainly lie within reasonable limits.
Language: JavaScript
Answer:
let num = [10,20,30];
average(num);
function average(num) {
let sum = 0;
for(let i in num) {
sum += num[i];
}
return console.log(sum/num.length);
}
Answer: the variable called errors is tested to see if it is less than it equal to 4
Answer:
The correct answer to the following question will be "RAID 5".
Explanation:
- RAID 5 is an obsolete array of the setup of independent disks that uses parity disk striping. RAID 5 classes have a total of three and no full hard drives (HDDs).
- RAID 5 is considered to be among the most stable RAID systems because the stability data is scattered throughout all drives.
- In a RAID 5 package, the minimum amount of disks is three (two for records, and one for variance). The maximum amount of disks in a RAID 5 system is infinite in principle even though your disk array may have created-in limitations. RAID 5 however only defends against a single failure of the motor.
Therefore, this will be the right answer.
