Answer:
The correct answer is 2. provides the supporting reasons before the primary message.
Explanation:
Hello!
Time interest earned ratio=income before tax and interest expenses÷interest expenses
3=X÷40000
Solve for x
X=3×40000
X=120000 This is income before tax and interest expenses but we need to figure out earning before tax only as required so
Earning before tax=120,000−40,000
=80,000. Answer
Good luck!
Answer:
$650,752
Explanation:
The computation of the avoidable interest is shown below;
But before that following calculations must be done
Interest payable on short term loan
= $2,240,000 × 10%
= $224,000
Interest payable on long term loan
= $1,600,000 × 11%
= $176,000
Therefore,
Weighted average interest rate is
= ($224,000 + $176,000) ÷ ($2,240,000 + $1,600,000) × 100
= 10.42%
Now
Avoidable interest is
= [$3,200,000 × 12%] + [($5,760,000 - $3,200,000) × 10.42%]
= $650,752
Answer:
retention ratio
Explanation:
Retention ration is the portion of net income retained by a firm to grow its business rather than being declared and paid as dividened.
When a company makes profit at the end of financial period, the company can either retain part of its earning for business expansion, declare part as dividends paid to shareholder or combine both.
Where a firm now reinvest the portion of the profit earned in itself, it is called retention ratio.
Answer:
A sample is taken from production and it is found that the cans average 61 psi with a standard deviation of 2 psi.
Explanation:
After the checks of the QC manager, it is deduced that a sample is been taken from the production and it is also found that the kergs average 61 psi woth a standard deviation of 2 psi.
Hydraulic fittings are available in threaded, thread-forming, rivet and drive styles. They are available in different angled configurations and a wide variety of extension lengths to allow you to position the fitting for easy access with a grease gun on different types of equipment.
Another factor to consider is the type of grease fittings used in the facility. Most fittings have a ball check in the head of the fitting, which prevents dirt from getting to the bearing. The spherical contour of the fitting head provides a ball-and-socket joint between the fitting and the hydraulic coupler of the grease gun. The most common fitting is the hydraulic fitting, available in standard and metric sizes.
