High specific heat of the water. Option (c)
What is Specific heat?
The amount of heat required to increase the temperature of one gram of a substance by one degree Celsius is referred to as the substance's specific heat. Typically, calories or joules are used per gram and degree Celsius when referring to the units of specific heat.
The moderate temperature of islands has much to do with the water's high specific heat. The typical off-water is more significant than this clear land or soil. Due to this fact, water absorbs and releases eat more slowly. In comparison to the land.
Hence, the water has high specific heat.
To learn more about specific heat the link is given below:
brainly.com/question/12982780?
#SPJ4
Gravitational Potential Energy GPE = mg∆h. 12. A 5.0 kg mass is initially sitting on the floor when it is lifted onto a table 1.15 meters high at.
Hey
Potential Difference given is : 2V
Resistance is : 2 ohms
By Ohm's Law, one can easily utilize the relation :

Where, { v , i , r } are the potential difference, current and Resistance Respectively.
Hence,

Hence, the Current is 1 Ampere
Answer:
Explanation:
Rx = -28.2 units
Ry = 19.6 units
magnitude of R = √ [( - 28.2 )² + ( 19.6 ) ]
= √ ( 795.24 + 384.16 )
= 34.34 units
If θ be the angle measured counterclockwise from the +x-direction
Tanθ = 19.6 / - 28.2 = -0.695
θ = 180 - 34.8
= 145.2° .
Answer:
Rotating the loop until it is perpendicular to the field
Explanation:
Current is induced in a conductor when there is a change in magnetic flux.
The strength of the induced current in a wire loop moving through a magnetic field can be increased or decreased by the following methods:
By increasing the strength of the magnetic field there will be increased in the induced current. If the strength of the magnetic field is decreased then there is a decrease in induced current.
By increasing the speed of the wire there will be increased in the induced current. When the speed of the wire is decreased then there is a decrease in induced current.
By increasing the number of turns of the coil the strength of the induced current can be increased. when there is less number of turns in coils then there is a decrease in induced current.
Rotating the loop until it is perpendicular to the field will not increase the current induced in a wire loop moving through a magnetic field.
Therefore, the option is (c) is correct.