Answer:
4 steps
Explanation:
Step 1: Pull belt across body
Sit in any of your vehicle's seats and secure the three-point harness in its buckle by pulling it across your body.
If the seatbelt is too short, consider an aftermarket restraint and extender. Make sure they meet federal safety standards and are installed professionally.
Step 2: Adjust lower belt
Adjust the lower belt snuggly across your lap and pelvis area – never your stomach.
Pregnant women should wear the lap belt below their belly, not on or above it.
Step 3: Adjust shoulder belt
Adjust the shoulder belt to fit comfortably across the collarbone and chest. It should never rub on your neck or face. Never put the shoulder belt behind your back or under your arm.
Step 4: Check before driving
Check that the belt is secure before driving.
I believe your answer would be:
1: Open the command prompt window. Do this by clicking the "Start" button, and then selecting "Run." In the window that appears, type "cmd" into the text box and click the "OK" button.
2: Release the computer's current IP address. To do this, type "ipconfig /release" into the command prompt window and press Enter.
3: Acquire a new IP address. Do this by typing "ipconfig /renew" into the command prompt window and pressing Enter. This should assign the computer a new IP address, which will be different from the previous address.
4: Cycle your modem's power. If the above steps don't work, you can try renewing your IP address by cycling your modem's power. Turn off both your computer and your modem (and your router, if you have one). Wait at least 5 minutes, then turn everything back on. If your computer is set to receive an IP address dynamically (the most likely configuration), you should be assigned a new IP address automatically.
5: Check to make sure your IP address has changed. To do this, you can log on to a number of different websites that tell you your IP address.
Hope I helped, if so may I get brainliest and a thanks?
Thank you, Have a good day! =)
I believe it is 200 per revolution!
Answer:
a and d
Explanation:
A. Run the parted command
D. Reboot the system
These two actions will make it easier to manually reload the fdisk