Answer:
ALTER TABLE Products
ADD Products_price float(5,2) DEFAULT 9.99,
ADD Adding_time datetime;
Explanation:
So at first we need to use ALTER TABLE statement, when we use this statement we also need to provide the table name. In this case, i assume it is 'Products'.
Then, as per question, we need to add two columns.
The first one is 'product_price' and it contains decimal points. So, we need to use ADD statement and give a column name like 'Prodcuts_price' and its datatype 'float' because it contains decimal or floating points. so, for 3 digits on the left and 2 digits on the right, it makes a total of 5 digits. So, we need to declare it like this. (5,2) it means a total of 5 digits and 2 after the decimal point. after that, we need to set our Default value using the DEFALUT statement. so DEFAULT 9.99. it will set the default value to 9.99 for existing products.
And for our next column, we give its a name like 'Adding_time' then it's datatype 'datetime' because it will contain date and times.
Idek but hope u figure it out!
Answer:
All the ports in a hub are in the same collision domain and a hub sends frames from one host to all other hosts in the network. This makes it prone to collision and poor network throughput. Just like a network switch, it uses the CSMA/CD protocol to detect collision in its network.
A network switch reduces its collision domain to just a port and sends frames from one host to another using its mac table as a route. This makes the network very efficient with high throughput. It also uses the CSMA/CD protocol to detect collision
Explanation:
Switches and hubs are used in networking to connect computer devices in a network. A hub is an obsolete device networking that broadcast a frame to all other ports or host in the network except for the send host port. This increases the rate of collision as all the ports in a hub share the same collision domain. A switch is an efficient frame switching device in a network, which uses its MAC table to decide and find a destination host.
CSMA/CD is a collision detection protocol used in a network to detect and prevent a collision. With this protocol, a host is able to listen, wait, send and resend frames to prevent a collision.
The body part that is close to the arc flash boundary is the energized conductors or circuit parts.
<h3>What is the distance of an arc flash?</h3>
The working distance is known to be the distance that exist between a person and the center of an arc flash.
Note that The body part that is close to the arc flash boundary is the energized conductors or circuit parts.
Learn more about Energy from
brainly.com/question/13881533
#SPJ1
