Answer:
molar mass = 180.833 g/mol
Explanation:
- mass sln = mass solute + mass solvent
∴ solute: unknown molecular (nonelectrolyte)
∴ solvent: water
∴ mass solute = 17.5 g
∴ mass solvent = 100.0 g = 0.1 Kg
⇒ mass sln = 117.5 g
freezing point:
∴ ΔTc = -1.8 °C
∴ Kc H2O = 1.86 °C.Kg/mol
∴ m: molality (mol solute/Kg solvent)
⇒ m = ( - 1.8 °C)/( - 1.86 °C.Kg/mol)
⇒ m = 0.9677 mol solute/Kg solvent
- molar mass (Mw) [=] g/mol
∴ mol solute = ( m )×(Kg solvent)
⇒ mol solute = ( 0.9677 mol/Kg) × ( 0.100 Kg H2O )
⇒ mol solute = 0.09677 mol
⇒ Mw solute = ( 17.5 g ) / ( 0.09677 mol )
⇒ Mw solute = 180.833 g/mol
Answer:
hgfdjsuejssj_uyghgjiyr656⁸8⁴83jbv
Once the student has finished his experiment, additional steps he may take are to analyze the data gathered and draw a conclusion, then publish his findings to be seen by his peers (other students).
<h3 /><h3>What comes after the experiment?</h3>
- Once an experiment is concluded, one must go over the data gathered.
- By this, we mean to analyze the information obtained through the experiment.
- This allows the student to draw a conclusion backed by evidence.
- Once complete, it is wise to share and discuss the findings with peers.
Therefore, we can confirm that once the experiment is completed, the most common action that follows is to draw a conclusion based on the analysis of the data gathered during the experiment, then discuss the findings with peers.
To learn more about experiments visit:
brainly.com/question/9199868?referrer=searchResults
Answer:
Option D: More than 30 seconds
Explanation:
The enzyme CATALASE is found in almost all living organisms. CATALASE helps in the decomposition of one substance into another substance. CATALASE will breaks down hydrogen peroxide into water and oxygen.
When the potatoes were boiled it will surely produce no bubbles because the heat would have degrade the enzyme - catalase While the potatoes at room temperature potato produced the most bubbles because catalase works best at a room temperature.
If the potato solution was boiled for 10 minutes and cooled for 10 minutes before being tested, the average time for the disks to float to the surface of the hydrogen peroxide solution would be MORE THAN 30 SECONDS