You yourself put the answer to the question in the Question. the answer is paragraph. lol
Based on the configuration written below, the most likely cause of the problem is Incorrect subnet mask.
<h3>What is an Incorrect Subnet Mask?</h3>
The issue of an Incorrect Subnet Mask will take place if a network uses a subnet mask that is not theirs for its address class, and a client is still said to be configured with the same default subnet mask for the address class, and thus communication tend to fail to some closeby networks.
Therefore, Based on the configuration written below, the most likely cause of the problem is Incorrect subnet mask.
Learn more about subnet mask from
brainly.com/question/27418272
#SPJ1
See full question below
You manage a network that has multiple internal subnets. You connect a workstation to the 192.168.1.0/24 subnet.
This workstation can communicate with some hosts on the private network, but not with other hosts. You run ipconfig /all and see the following:
Ethernet adapter Local Area Connection: Connection-specific DNS Suffix . : mydomain.local Description . . . . . . . : Broadcom network adapter Physical Address. . . . . . : 00-AA-BB-CC-74-EF DHCP Enabled . . . . . . . : No Autoconfiguration Enabled. . . : Yes IPv4 Address . . . . . . . : 192.168.1.102(Preferred) Subnet Mask. . . . . . . . : 255.255.0.0 Default Gateway . . . . . . : 192.168.1.1 DNS Servers . . . . . . . : 192.168.1.20 192.168.1.27
What is the most likely cause of the problem?
Based on the information about the network, Cat 5e cabling posseses more twists per inch than Cat 3 cabling, and this will thereby reduce cross-talk and support higher data rates.
<h3>What is a network?</h3>
A network simply means a group of two or more computers that are interconnected for the purpose of exchanging data as well as sharing resources.
In this case, while Cat 3 and Cat 5e cabling appear the same physically, they are electrically different. It should be noted that Cat 5e cabling is twisted tighter than Cat 3 cabling and this will then reduce cross talk and enables Cat 5e wiring to support faster data transmission.
Learn more about network on:
brainly.com/question/26956118
#SPJ1
You are installing networking wiring for a new Ethernet network at your company's main office building. The project specifications call for Cat 5e UTP network cabling and RJ45 wall jacks. Near the end of the project, you run out of wire before the last few runs are complete. You have a spool of Cat 3 network cable in storage. Upon investigation, it appears very similar to Cat 5e wiring.
Should you use Cat 3 cabling as a substitute for Cat 5e cabling to finish the project?
Answer:
they use it when they are driving and when they dont know where they are doing
Explanation:
Answer: Environment sensing Collector
Explanation:
An environmental monitoring system or collectors is the process which a device uses in monitoring the quality of the environment. These devices or software allows for a realtime monitoring and checking of any parameter required. They are used to monitor and collect data on environmental conditions such as relative humidity, temperature, dew and frost point, differential pressure, pressure, flow, and many more.
