Uni code is short for universal code , it was created so that all countries could communicate together without the need for special encoding for each country
It would take 2 consultants 30 hours to create a slide deck of 120 slides.
Explanation:
Rate of slide making by one consultant- 2 slides per hour
Target- 120 slides
2 consultants are employed in the job-
Since 2 consultants are employed in the job, total rate of making slides per hour would be 4 slides/hour (2*2 slides/hour)
Time required to complete 120 slides= total slides/rate of doing slides per hour
Substituting the values, we get
Time required= 120/4= 30 hours
Hence, it would take 30 hours for 2 consultants to create a slide deck of 120 slides.
Statement two and three is correct.
Statement 1 is incorrect. A relative reference changes when a formula is copied to another cell while Absolute references remain constant. However, it is safe to say that an absolute address can be preceded by a $ sign before both the row and the column values. It is designated by the addition of a dollar sign either before the column reference, the row reference, or both. Statement C is also correct. A mixed reference is a combination of relative and absolute reference and the formula (= A1 + $B$2) is an example of a mixed cell reference.
Answer:
Packets with unknown source addresses will be dropped.
Explanation:
This question is incomplete, we must add the number "1" in Fa0/1.
Which event will take place if there is a port security violation on switch S1 interface Fa0/1?
There are four options:
- A notification is sent.
- A syslog message is logged.
-The interface will go into error-disabled state.
- Packets with unknown source addresses will be dropped.
In this specific example, we have configured a security protection mode, if there is an unknown MAC address, every package will be dropped.
We can configure in our switch with different Mac address, if there is not a MAC address in our configuration, the security mode will active, and we could receive any package.
Here are the steps I would do:
Do a "hard" power off. Hold the power key until the screen turns off. Wait 10 seconds. Turn it on. If it still shows the screen... then i'm not sure.
The error is occurring because it has nothing to boot off of. It's probably something wrong with your hardware. The instructions say for you to insert a "boot disk" and press any key.
