Answer:
What do they look like?
Glaciers look like solid blocks of ice.
What climate do they exist in?
Regions that have high snowfall in winter and cool temperatures in summer.
Where can you find them?
Most of the world's glacial ice is found in Antarctica and Greenland, but glaciers are found on nearly every continent, even Africa.
What do you think we can learn from glaciers?
Glaciers preserve bits of atmosphere from thousands of years ago in these tiny air bubbles, or, deeper within the core, trapped within the ice itself. This is one way scientists know that there have been several Ice Ages. Scientists are also finding that glaciers reveal clues about global warming.
(The last question is unclear to me, so I'm going to take a guess as to what you meant)
Why is sea ice so important?
Arctic sea ice keeps the polar regions cool and helps moderate global climate.
I hope this helps!! :3
If one year was a foot then 65 million years will be 65 million feet. 1 mile=5280 feet so.
65 million divided by 5280= 12310.6
So your answer would be 12,310 miles.
Explanation:
Wind energy, or wind power, is created using a wind turbine, a device that channels the power of the wind to generate electricity. The wind blows the blades of the turbine, which are attached to a rotor. The rotor then spins a generator to create electricity . Wind energy is a renewable energy source that is clean and has very few environmental challenges. Wind power actually starts with the Sun. In order for the wind to blow, the Sun first heats up a section of land along with the air above it. That hot air rises since a given volume of hot air is lighter than the same volume of cold air. Cooler air then rushes in to fill the void left by that hot air and voila: a gust of wind. The Office of Energy Efficiency and Renewable Energy describes a wind turbine as “the opposite of a fan.” Simply stated, the turbine takes the energy in that wind and converts it into electricity. So how does it do that? First, the wind applies pressure on the long slender blades, usually 2 or 3 of them, causing them to spin, much like the wind pushes a sailboat along its path through the water. The spinning blades then cause the rotor, or the conical cap on the turbine, and an internal shaft to spin as well at somewhere around 30 – 60 revolutions per minute. The ultimate goal is to spin an assembly of magnets in a generator which will, well, generate voltage in a coil of wire thanks to electromagnetic induction. Generators require faster revolutions, however, so a gear box typically connects this lower speed shaft to a higher speed shaft by increasing the spin rate to around 1000 to 1800 revolutions per minute. These gear boxes are costly as well as heavy, so engineers are looking to design more “direct-drive” generators that can work at the lower speeds.
Answer:
It looks like Telephase 1
Answer:
There is a protein synthesis cycle
Explanation:
The whole cycle goes through Transcription and Translation
where the DNA gets converted into RNA
