Answer:
Forward Compatible
Explanation:
If a piece of software designed to run on Windows XP can run on the latest version of Windows, we say the latest version of Windows is Forward Compatible.
Forward compatibility or upward compatibility is a design characteristic that allows a system to accept input intended for a later version of itself. The concept can be applied to entire systems, electrical interfaces, telecommunication signals, data communication protocols, file formats, and computer programming languages.
The objective for forward compatible technology is for old devices to recognise when data has been generated for new devices.
Answer:
Wait. Then you try it again
Explanation:
You wait and try again later and if this still persists, you may have to check the optical drive from the drive manager peradventure there is an issue there probably a software issue, also you may have to clean the optical drive using the cleaner disc, likewise you may need to test an old disc on the optical drive to be sure the fault is not from the disc you inserted.
After having verified that the video cable is installed correctly we should check to see that the computer's RAM is correctly fastened to the motherboard and functional.
The question states that the video card being installed is new, therefore we can comfortably assume that the card itself is not the issue. Other computer components that can cause a blank screen immediately upon powering on the workstation are:
- RAM
- Hard drive
- Bad video driver.
- Monitor input is faulty
however, assuming the installation was performed correctly, it is not likely to be caused by a bad video driver and a faulty monitor input is very improbable given that there are very few ways this can break to begin with.
A bad or missing hard drive may cause this kind of issue because the workstation will not have a windows file to boot. In most cases, this will not cause a completely blank screen without first allowing access to the BIOS.
After having verified that the video cable is installed correctly, the very next thing you should check is if the RAM is installed correctly. This is because the issue explained is exactly what will happen if a workstation attempts to boot without RAM, and also because it is the easiest fix among the possible causes and any troubleshooting should always be performed in order from the easiest fix to the most difficult.
To learn more visit:
brainly.com/question/2160588?referrer=searchResults
The issue would be that the memory was not installed or was not detected by the system. If this happens, the system boot will fail and a beep code is heard. The system would not show anything since all of the software are in the memory which was not installed or detected.
It's voice phishing but it's also sometimes referred to as vishing