Answer:
6=72 cm; 7=15 cm; 8=30 in; 9)56.5 degrees; 10)40 in
Step-by-step explanation:
6) The height of the triangle is 12 cm. The base is around 10 cm. Triangles are 1/2(b)h, so:
1/2(10)=5
5*12=60 cm
72 is closest to this.
7) Volume is l*w*h, so:
2.5*1.5=3.75
3.75*4=15 cm
8) Again, the height is 5 and the base is 12. 1/2(b)h means:
1/2(12)=6
6*5=30 in
9) All triangles have 180 degrees. So first, add the degrees you know:
33.5+90=123.5
Now, subtract that from 180:
180-123.5=56.5
10) Trapezoids can be found by multiplying the height by the smaller base, so:
6*8=40 in
Hope this helped!
Answer:
Roman
Step-by-step explanation:
An easy way to solve this is looking at whether the line has a positive or negative slope. We read graphs from left to right so <u>if the line is increasing from left to right, it has a positive slope while a line decreasing from left to right has a negative slope</u>. Since the line shown is decreasing from left to right, it will have a negative slope and Roman is the only one out of the two that shows a negative slope. To check to see if he's correct, we can check the y-intercept. The y-intercept of the line is 8 and Roman also has 8 written in the expression. Hence, meaning Roman is correct.
Best of Luck!
Answer:
there are 52 cards in a deck so the chance is a red card (or not a red card) is 26 out of 52.
Step-by-step explanation:
Answer:
i can only see 3
Step-by-step explanation:
Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.