Explanation:
As we know that
time = distance/speed
The time used for firs half of the trip was
(1 mi)(12 mi/hour) = 1/12 hours = 5 minutes
The last half of the trip will took 10 minutes, 1/6 hour.
Speed = distance/ time
(1 mil) = (1/6h) = 6 mil/h
so the speed for last half of the trip was = 6mph
the average speed was
(2mil)(1/4 hour) = 8 mil/hour
So the ling's average speed was 8mph.
Answer:
well divide 400 by 3 and you should get how fast you're going aka (speed)
Answer:
Deposition
Explanation:
- Deposition occurs when water slows or ceases moving, the wind dies or stops blowing, or glaciers melt. The deposited material can also be used to construct new landforms. Waves, for example, can dump sediment in places offshore, where it might accumulate to form sand dunes.
When the wind calms down or vegetation stops or slows the breeze, the sediment particles begin to fall. Water is another factor that may erode, move, or deposit sediment. Flowing water is a key erosive agent. Water transports dirt and rock fragments as it moves. Warm, wet air will not travel if wind systems are not present. Water will still evaporate, but it will not move, therefore everywhere else than a major body of water will dry up. Lakes may be fine since evaporating water will flow back into them, and the sea will be fine, but everywhere else will become extremely dry very rapidly. Wind is constantly blowing somewhere on the world at any given time. Winds are usually quiet near the middle of a high pressure system. Wind is the passage of air from a high pressure location to a low pressure area.... So essentially air is always moving. Weathering and erosion are caused by wind. Weathering is caused by wind blowing debris against cliffs and huge rocks. This wears down the rock, reducing it to sand and dust. Sand and dust are also eroded by wind. 2. Rocks are tough and durable, but they don't last forever. Weathering and erosion are processes that occur as a result of forces such as wind and water breaking down rocks. Weathering is the process through which rocks deteriorate. Weathering is caused by a variety of factors, including climate change.
Answer:
P = 180 [w]
Explanation:
To solve this problem we must use ohm's law, which is defined by the following formula.
V = I*R & P = V*I
where:
V = voltage = 200[volts]
I = current [amp]
R = resistance [ohm]
P = power [watts]
Since the bulbs are connected in series, the powers should be summed
P = 60 + 60 + 60
P = 180 [watts]
Now we can calculate the current
I = 180/200
I = 0.9[amp]
Attached is an image where we see the three bulbs connected in series, in the circuit we see that the current is the same for all the elements connected to the circuit.
And the power is defined by P = V*I
we know that the voltage is equal to 200[V], therefore
P = 200*0.9
P = 180 [w]
Search Results
Featured snippet from the web
Reproduction is a biological process for the development of a new organism from scratch.