Answer: (D) Must always have a data store if there are paper documents involved.
Explanation:
A system flowchart is basically responsible for displaying the data in the system and also control the flow of data. The system flowchart are basically use various graphic symbol for representing the systematic manner for processing the output.
It basically contain data store in the system if there is data documents present in the system so that it make easy to store the data in the system.
There are basically four symbols that is use to represent in the program flowchart is that are: Firstly start, processing, decision making and then end.
Answer:
cyber-extortion
Explanation:
Ashley Baker has been the webmaster for Berryhill Finance only ten days when she received an e-mail that threatened to shut down Berryhill's website unless Ashley wired payment to an overseas account. Ashley was concerned that Berryhill Finance would suffer huge losses if its website went down, so she wired money to the appropriate account. The author of the e-mail successfully committed cyber-extortion.
Answer:
In order to reduce the risk of accidents on the roads.
Explanation:
The special equipment is used when testing eyesight for a driver's license in order to reduce the risk of accidents on the roads. Good eyesight is very important for good and safe driving so to find out the eyesight of the driver, the license officer used special equipment in order to check driver's eyes. If the eyesight is good, the officer provide license to the person otherwise not so that no accidents happen on the road.
A sixteen bit microprocessor chip used in early IBM PCs. The Intel 8088 was a version with an eight-bit externaldata bus.
The Intel 8086 was based on the design of the Intel 8080 <span>and </span>Intel 8085 (it was source compatible with the 8080)with a similar register set, but was expanded to 16 bits. The Bus Interface Unit fed the instruction stream to theExecution Unit through a 6 byte prefetch queue, so fetch and execution were concurrent - a primitive form ofpipelining (8086 instructions varied from 1 to 4 bytes).
It featured four 16-bit general registers, which could also be accessed as eight 8-bit registers, and four 16-bit indexregisters (including the stack pointer). The data registers were often used implicitly by instructions, complicatingregister allocation for temporary values. It featured 64K 8-bit I/O (or 32K 16 bit) ports and fixed vectored interrupts.There were also four segment registers that could be set from index registers.
The segment registers allowed the CPU to access 1 meg of memory in an odd way. Rather than just supplyingmissing bytes, as most segmented processors, the 8086 actually shifted the segment registers left 4 bits and addedit to the address. As a result, segments overlapped, and it was possible to have two pointers with the same valuepoint to two different memory locations, or two pointers with different values pointing to the same location. Mostpeople consider this a brain damaged design.
Although this was largely acceptable for assembly language, where control of the segments was complete (it couldeven be useful then), in higher level languages it caused constant confusion (e.g. near/far pointers). Even worse, thismade expanding the address space to more than 1 meg difficult. A later version, the Intel 80386, expanded thedesign to 32 bits, and "fixed" the segmentation, but required extra modes (suppressing the new features) forcompatibility, and retains the awkward architecture. In fact, with the right assembler, code written for the 8008 canstill be run on the most <span>recent </span>Intel 486.
The Intel 80386 added new op codes in a kludgy fashion similar to the Zilog Z80 and Zilog Z280. The Intel 486added full pipelines, and clock doubling (like <span>the </span>Zilog Z280).
So why did IBM chose the 8086 series when most of the alternatives were so much better? Apparently IBM's own engineers wanted to use the Motorola 68000, and it was used later in the forgotten IBM Instruments 9000 Laboratory Computer, but IBM already had rights to manufacture the 8086, in exchange for giving Intel the rights to its bubble memory<span> designs.</span> Apparently IBM was using 8086s in the IBM Displaywriter word processor.
Other factors were the 8-bit Intel 8088 version, which could use existing Intel 8085-type components, and allowed the computer to be based on a modified 8085 design. 68000 components were not widely available, though it could useMotorola 6800 components to an <span>extent.
</span>
Hope this helps
Answer:
The formula to enter in E14 is as follows:
=DAYS(D14,$E$10)
Explanation:
Required
Formula to calculate the number of days between E10 and D14
The syntax to do this is:
=DAYS(end_date,start_date)
So, we have:
=DAYS(D14,E10)
The question requires a mix of relative and mixed references because cell E10 will be constant in calculating the difference for dates in other cells.
In other words, the initial date is constant for all
So, the update formula is:
=DAYS(D14,$E$10)
Notice the $ between in E10; this represents mixed referencing
When dragged to E15 till E68, the formulas in the respective cells will be:
=DAYS(D15,$E$10) .............................. =DAYS(D68,$E$10)
