Answer:
T10BASE-T networks require a minimum of Category 3 cable and connection hardware for proper operation.
Explanation:
The characteristics of this cable:
1. Complies with EIA / TIA - 568-B ISO / IEC 11801 Class C
2. 0.51 mm (24 AWG) solid copper conductor
3. PE (Polyethylene) insulation,
4. PVC outer cover,
5. no flame propagator and
6. self-extinguishing.
7. Twisted pair
8. SUITABLE FOR VOICE AND DATA INSTALLATIONS FROM 10Mbps to 16Mbps.
<u>It is suggested to buy the complete coil to change the wiring gradually.
</u>
Answer:
This is because, the advertisers report the storage space in decimal while the computer reads the storage space in binary.
Explanation:
The advertisers report the storage space in decimal or base 10 because humans count in decimal, whereas the computer reports the storage space in binary or base 2.
Since the computer storage is in bytes and 8 bits equal 1 byte, It is easier to write a storage space of 1 kB as 1000 B but it is actually supposed to be 1024 B(2¹⁰). So, there is a discrepancy of 1024 B - 1000 B = 24 B.
As we go higher, the discrepancy increases. For example, 1 MB is advertised as 1000 kB = 1000000 B but is actually supposed to be 1024 kB = 1024 × 1024 B = 1048576 B. So, there is a discrepancy of 1048576 B - 1000000 B = 48576 B.
So, the actual number of bytes on the storage device is actually less than that reported due to the different number systems in which they are reported in. This discrepancy is less in memory cards or flash drives though in which the stated value of storage capacity might be the actual storage size.
Note that the base 10 or decimal system was chosen by advertiser since this is what consumers understand.
Answer:
right click and press control c
This gap between user-designer communications <span>can cause a good project to go bad i</span>f the user is not able to process what is required to be fixed in order for the project to run smoothly. The user may have one way of fixing something while the designer has another. In this case, the designer understands how the project fully works while the user does not and this may end up compromising the whole project.
The law that “designers are not users” and “users are not designers” should always be followed.
