Answer:
Flow velocity
50.48m/s
Pressure change at probe tip
1236.06Pa
Explanation:
Question is incomplete
The air velocity in the duct of a heating system is to be measured by a Pitot-static probe inserted into the duct parallel to the flow. If the differential height between the water columns connected to the two outlets of the probe is 0.126m, determine (a) the flow velocity and (b) the pressure rise at the tip of the probe. The air temperature and pressure in the duct are 352k and 98 kPa, respectively
solution
In this question, we are asked to calculate the flow velocity and the pressure rise at the tip of probe
please check attachment for complete solution and step by step explanation
Advantages include low costs and minimal labor.Water stays in the root zone, and foliage stays dry. Drawbacks to surface irrigation include potential overwatering and wasteful runoff.
inhalation is the most common way for chemical to enter the body
Answer:
Here you go!!
Explanation:
If I were to write a book I would write my steps down as in figuring out what I what to talk about. Have an Introduction- Using an introduction is needed because you need to Describe your main idea, or what the essay is about, in one sentence. ... Develop a thesis statement, or what you want to say about the main idea. ... List three points or arguments that support your thesis in order of importance (one sentence for each). I would also use a Rising action- This is needed because, To construct the plot, nearly any story can be said to use increasing action. It serves the following purposes: It generates suspense and enhances the sense of urgency around the story's central conflict or problem. Then I would do a Climax- The object of a climax is not to provide the most possible conflict or action. It's also not just about producing the character's greatest reversal of fortunes. Too often we mistake the fortunes of our character with the story's arc, and although fortune is involved, it's not our story arc's key criterion. After that, I would just add finish touches and finish it off before it needs to be shipped off to make copies.
Tell me why i got this question got it right and now won’t remember but i’ll get back at you when i remember
