First, rpm is RedHat Package Manager. Compilation is done with gcc, the GNU C Compiler.
To add that kernel to grub2's menu, as root you'd need to run:
grub2-mkconfig > /boot/grub2/grub.cfg #redirection is favored by Red Hat
Check out the man page @ man grub2-mkconfig
Answer:
Trap is a software interrupt that occurs when there is a system call, while hardware interrupt occurs when a hardware component needs urgent attention.
Explanation:
Interrupt is an input signal that disrupt the activities of a computer system, giving immediate attention to a hardware or software request.
In trap interrupt, the system activities are stop for a routine kernel mode operation, since it has a higher priority than the user mode. At the end of the interrupt, it switches control to the user mode.
The hardware interrupt is a signal from hardware devices like the input/output devices, storage and even peripheral devices that draws an immediate attention of the processor, stopping and saving other activities and executing the event with an interrupt handler.
Answer:
Check the explanation
Explanation:
when calculating the total time to send the I bits of information or The packet delivery time or latency which can be said to be the amount of time from when the first bit leaves the point of transmission until the last is received. When it comes to a physical link, it can be computed or determined as: Packet delivery time = Transmission time + Propagation delay.
Kindly check the attached image below to get the step by step explanation to the above question.
Answer:
There is no need to make an algorithm for this simple problem. Just add the two numbers by storing in two different variables as follows:
Let a,b be two numbers.
c=a+b;
print(c);
But, if you want to find the sum of more numbers, you can use any loop like for, while or do-while as follows:
Let a be the variable where the input numbers are stored.
while(f==1)
{
printf(“Enter number”);
scanf(“Take number into the variable a”);
sum=sum+a;
printf(“Do you want to enter more numbers? 1 for yes, 0 for no”);
scanf(“Take the input into the variable f”);
}
print(Sum)
Explanation:
hi there answer is given mar me as brainliest