PCI and AGP slots have been replaced with PCI-E slot (PCI-Express). There are different types of PCI-E buses:
PCI Express 1x (250 [500] * MB/s)
PCI Express 2x (500 [1000] * MB/s)
PCI Express 4x (1000 [2000] * MB/s)
PCI Express 8x (2000 [4000] * MB/s)
PCI Express 16x (4000 [8000] * MB/s)
<span>PCI Express 32x (8000 [16000] * MB/s)
I hope that's what you meant :)</span>
Answer:
C. Must be respected if we are to function as complete, self-governing agents.
Explanation:
<em>Privacy</em> is the boundaries that are set up to protect us against unwanted intrusion or interference, and it forms the basis of our interaction with the world.
<em>Privacy laws</em> are set-up to protect individuals from unwanted and unapproved access to privacy by individuals, organizations, and government. This is greatly adhered to in many countries.
To some extent, privacy is considered to overlap with security, because, when private information such as social security number, bank card details, account names, and details, etc. are accessed inappropriately, the individual's security is greatly compromised.
Therefore, privacy must be greatly respected if we are to function as complete, self-governing agents.
Answer:
The Arduino boards can be programmed in assembly. All you need is an ICSP Cable (In Circuit Serial Programmer) and the AVR toolchain (free from ATMEL) to write to the board. You then get the advantage of on board debugging.
As you suggested, you can just slap an ATMEL chip on a breadboard and go to town.
Explanation: cause i said so
Answer:
The program in Python is as follows:
total = 0
count = 0
for i in range(8):
num = float(input())
if num < 10.5:
total+=num
count+=1
print("Average: ",total/count)
Explanation:
This initializes the total to 0
total = 0
This initializes the count to 0
count = 0
This loop is executed 8 times
for i in range(8):
This request for float number
num = float(input())
If input is less than 10.5
if num < 10.5:
The sum is taken
total+=num
And count is incremented by 1
count+=1
The loop ends here
This calculates and prints the average
print("Average: ",total/count)
