<h3>
Answer is -15</h3>
We read this out as "negative 15" or you could write "negative fifteen".
The negative indicates the temperature went down. It doesn't necessarily mean that the final temperature is -15 degrees.
For example, if it starts being 50 degrees F, and drops by 15 degrees, then 50+(-15) = 50-15 = 35 degrees is the temperature after that drop. It might help to use a vertical number line.
Answer:
you talking to specific people or can anyone join
Step-by-step explanation:
Answer:
1. a
2. b (i think)
3. b
4. a
5. d
im not sure bout all this but h ope it helps you
Answer:
It takes 147 hours for the snow to reach 62 inches.
Step-by-step explanation:
Given:
Height of the snow at the beginning = 84 inches
Rate at which the snow melts = f 0.15 inches per hour
To Find:
The time taken for the snow to reach 62 inches = ?
Solution:
Let the time taken to reach 62 inches be x
Then according to the question,
Total height of the snow - (rate of melting)(x) = 62 inches
On substituting the values,
84 - (0.15)(x) = 62
84 - 0.15x = 62
- 0.15x = 62 - 84
- 0.15x = -22
0.15x = 22
x = \frac{22}{0.15}
x= 146.6
x = 147
<h3>
Answer: Choice B</h3><h3>
y = x^2 + 7x + 1</h3>
======================================
Proof:
A quick way to confirm that choice B is the only answer is to eliminate the other non-answers.
If you plugged x = 1 into the equation for choice A, you would get
y = -x^2 + 7x + 1
y = -1^2 + 7(1) + 1
y = -1 + 7 + 1
y = 7
We get a result of 7, but we want 9 to be the actual output. So choice A is out.
-----------
Repeat for choice C. Plug in x = 1
y = x^2 - 7x + 1
y = 1^2 - 7(1) + 1
y = 1 - 7 + 1
y = -5
We can eliminate choice C (since again we want a result of y = 9)
-----------
Finally let's check choice D
y = x^2 - 7x - 1
y = 1^2 - 7(1) - 1
y = 1 - 7 - 1
y= -7
so choice D is off the list as well
-----------
The only thing left is choice B, so it must be the answer. It turns out that plugging x = 1 into this equation leads to y = 9 as shown below
y = x^2 + 7x + 1
y = 1^2 + 7(1) + 1
y = 1 + 7 + 1
y = 9
And the same applies to any other x value in the table (eg: plugging in x = 3 leads to y = 31, etc etc).