Because infrared telescopes use infrared aka anything above absolute zero (0 degrees Celsius or 32 degrees Fahrenheit) meaning that the telescope would not only pick up the stars but also all of the people and lights so on and so forth
ANSWER: BOT
EXPLANATION: When a PC is experiencing the listed effects, it thus depicts that the PC is under attack by a bot, which is a type of script or software application that establishes automated tasks via command.
However, a bad bots often initiate malicious tasks that gives room for attackers to take control over an affected PC remotely, most especially for fraudulent activities.
When several affected computers are connected, they form a botnet connection.
Answer:
Troubleshooting
Explanation:
These actions are called troubleshooting.
Troubleshooting is used to diagnose the unexpected error while you are performing some action on the computer. For example
You are running skype, and a one-day mic or sound performing unexpected error. What will you do? You have to perform the troubleshooting for MIC and sound to diagnose the problem.
During troubleshooting, you will wizard through steps of the procedure to diagnose the problem step by step. If the problem will be identified, the solution will be suggested.
You may experience sometimes your Wifi router at home not working. For this to identify the unexpected error you will perform the troubleshooting.
In short, troubleshooting is used to diagnose unexpected error while performing some action on the computer. If troubleshooting does not work, then close all the programs running on your machine, then shut down your computer. Wait a couple of minutes, and then start your computer and see, the problem may have been alleviated.
Answer:
1.) 25 ; 15 ; 15
2.) 50 ; 15 ; 50
Explanation:
In the first function written :
The variable val was initially decaled or assigned a value of 25 and that was what was printed first.
However, after the example function was written, the val variable was finally assiagned a value of 15 within the function. However, it was also declared that the global variable takes uonthe val value. Hence, the val variable initially assigned a value, of 25 changes to 15 globally.
For the second code :
From the top:
Val was assigned a value of 50 ;
Hence,
print(val) gives an output of 50
Within the function definition which prints the value of val that is assigned a value of 25 within the function.
Since tbe global variable isnt reset.
Printing Val again outputs 50;since ito is outside the function.
<span>Before allowing a person to
operate PWC, check that they meet the minimum age and boater education
requirements for PWC. While near shore, show how to start and re board the PWC properly
and make sure that he has at least 25 hours of PWC operation experience. Be sure
explain how to steer and control the PWC properly.</span>
