I believe that the multiple questions attached to this question is
a) Hello
b) Link groups
c) Path groups
d) Heartbeats
The Answer is B and C
The physical interfaces that are supposed to be monitored are connected into a link group and a firewall failure can be triggered when one or all physical interfaces in the group failPath Monitoring helps monitor the full path to mission critical IP addresses. By default, any one of the IP addresses becoming unreachable will end up causing the firewall to change the HA to tentative state
Answer:
gpresult
Explanation:
Group Policy provides the system administrator with settings that would be necessary to manage the different user accounts available in an organization. It also controls their work environment centrally by configuring the user Operating System (OS), applications and user accounts.
Group policy settings or configurations are referred to as Group Policy Objects (GPOs). These objects can be linked to organizational units (OUs), domains or sites.
There are various group policy commands such as;
- rstrui (System Restore tool will run),
- runas (using different permission to run a tool or program),
- tasklist (currently running programs are shown
- gpupdate (Group policies are refreshed)
- gpresult (group policy configurations are displayed for verification)
gpresult command can be used to verify the group policy configurations for adjustment or optimization. The technician can start troubleshooting from viewing the active settings, then running the rstrui to start the System Restore utility to restore the computer to an earlier date
Answer:
The correct answer to the following question will be "Multipath I/O
".
Explanation:
Multipath I/O going to minimize the impact of a failure of either the host network interface by offering an alternative access route through storage media as well as a Windows OS.
- It offers the possibility for someone like you to support high accessibility and significantly improve efficiency based on your SAN setup.
- Offer valuable even fault resistance to a terminal server by using different objectives or paths.
So, you should install this Multipath I/O.
once you have sent the email it will only go to the server which then the person receiving it would log on therefore requesting the emails recived.
I'm not 100% sure my answer is classed as correct but I would say it doesn't go to a computer it just gets stored on a server in till requested
