Answer:
Explanation:
We start from the bottom-most and rightmost internal node of min Heap and then heapify all internal modes in the bottom-up way to build the Max heap.
To build a heap, the following algorithm is implemented for any input array.
BUILD-HEAP(A)
heapsize := size(A)
for i := floor(heapsize/2) downto 1
do HEAPIFY(A, i)
end for
Convert the given array of elements into an almost complete binary tree.
Ensure that the tree is a max heap.
Check that every non-leaf node contains a greater or equal value element than its child nodes.
If there exists any node that does not satisfy the ordering property of max heap, swap the elements.
Start checking from a non-leaf node with the highest index (bottom to top and right to left).
Tables are used to display information in a more arranged and organized manner.
Various ways of adding a row in an already existing table are:
1) By drawing a row in the table using the draw option.
2) By using the insert option under the Table Tools tab.
3) By designing the table with an added row using the Design tab.
<u>Explanation:</u>
In the insert option, go to the extreme right corner. There appears an option of Draw Table. Draw another row and it gets added.
This tab contains two tabs, Design and Layout that enable you to rapidly arrange your table, embed or erase lines and sections, set the arrangement for cells, and organization the typography of the content in your table.
Thus, a table and its capacity are built up from here on and open for designing.
National FFA is the answer to your question my guy.
Answer it gives u points I think
Explanation: