To delete only the selected contents of the table, but not the table itself, you need to click on this cell in the table.
Answer:
The solution code is written in Python 3:
- def modifyList(listNumber):
- posCount = 0
- negCount = 0
-
- for x in listNumber:
- if x > 0:
- posCount += 1
- else:
- negCount += 1
-
- if(posCount == len(listNumber)):
- listNumber.append(max(listNumber))
-
- if(negCount == len(listNumber)):
- listNumber.append(min(listNumber))
-
- print(listNumber)
-
- modifyList([-1,-99,-81])
- modifyList([1,99,8])
- modifyList([-1,99,-81])
Explanation:
The key step to solve this problem is to define two variables, posCount and negCount, to track the number of positive value and negative value from the input list (Line 2 - 3).
To track the posCount and negCount, we can traverse through the for-loop and create if else statement to check if the current number x is bigger than 0 then increment posCount by 1 otherwise increment negCount (Line 5- 9).
If all number in the list are positive, the posCount should be equal to the length of the input list and the same rule is applied to negCount. If one of them happens, the listNumber will append either the maximum number (Line 11 -12) or append the minimum number (Line 14-15).
If both posCount and negCount are not equal to the list length, the block of code Line 11 -15 will be skipped.
At last we can print the listNumber (Line 17).
If we test our function using the three sets of input list, we shall get the following results:
[-1, -99, -81, -99]
[1, 99, 8, 99]
[-1, 99, -81]
Once the reaction time experiment in your MakeCode micro:bit program is complete, Review the tutorial video to make sure you've completed all the steps correctly.
<h3>What is reaction time experiment?</h3>
A reaction time experiment is known to be one that has different set of neural processes. This experiment is known to be one that has been set up to measure or look into the response time for something that one can see.
Note that when the reaction time experiment in your MakeCode micro:bit program is complete, it is better to go over the tutorial video to be sure you that you have completed all the steps correctly.
learn more about reaction time from
brainly.com/question/6167212
The answer is already given at the end of the question; solely by the magnitude or severity of expected harm
When assessing risks of harm associated with participation in a research study, the probability of harm and the risk of the severity of harm are two distinctive elements of risk that must be considered. In probability of harm, the fact that not all possible harms are equally probable should be considered. How these two elements occur is a crucial factor in determining the level of risk of harm in a study. Given the sensitivity of the information in the case scenario above, the probability that an individual subject could be identified is low while the magnitude of the possible risk of harm is high.
Answer:
Do this:
Position the insertion pointer where you want the index to appear. If you want the index to start on a new page, create a new page in Word. ...
Click the References tab.
In the Index group, click the Insert Index button. The Index dialog box appears. ...
Click the OK button to insert the index into your document.