The quantity that is measured in Kelvin is temperature.
Most of the time, especially in chemistry, they must convert Celsius into kelvin by adding 273.15 to Celsius. K = C + 273.5
Hope this helps!
Normally they have equal protons and neutrons
We may apply Fleming's Left Hand Rule of Electromagnetism to determine how a charged particle behaves in a magnetic field. However, because the gamma rays do not have a charge on them, like alpha particles and beta particles do, they are not deflected.
Gamma rays are electromagnetic waves and its is a characteristic of electromagnetic waves that they have no charge.
Answer:
C. It is a male with atleast one dominant allele
Explanation:
In the given pedigree, the two normal parents of the generation I have one daughter with the attached earlobe. Since the trait is recessive, the daughter should be homozygous recessive to express the trait. The genotype of the daughter (shaded circle in generation II) is "aa". To have a daughter with "aa" genotype, both the parents should have one copy of "a" allele. So, the genotype of both parents is "Aa".
In generation II, individual A is non-shaded square. Squares represent males in a pedigree. Since its not shaded, it does not have attached earlobe. Both the parents are heterozygous dominant for attached earlobes (Aa x Aa = 1/4 AA : 1/2 Aa : 1/4 aa). The genotype of this individual may be AA or Aa.
Answer:
The observed image will not be sharp
Explanation:
When 100x microscope objective lens is being used, light refraction in the air is enough high to produce image alterations. Image distortions can be minimized by immersion oil because this liquid has a higher refractive index than air. However, light refraction is not usually noticeable when using 4x, 10x and 40x objective lenses. Moreover, this image will not be sharp after putting oil on the slide and going back to the 40x objective, it is for that reason that the 40x is called 'high dry' lens. In consequence, it is required to clean the immersion oil off the 40x objective. In general, it is required to to remove the oil and refocus off the slide and lens immediately after oil immersion (it can be done by using an oil-soluble solvent).
