Answer:D
Queries are always saved and can therefore be run on the most up-to-date database information
A command you would use to perform a reverse lookup of the IP address 10.0.0.3 on a Linux system: dig -x 10.0.0.3.
<h3>What is a Linux command?</h3>
A Linux command can be defined as a software program that is designed and developed to run on the command line, in order to enable an administrator (end user) of a Linux network perform both basic and advanced tasks by only entering a line of text.
<h3>What is IP address?</h3>
IP address is an abbreviation for Internet protocol address and it can be defined as a unique set of numbers that are assigned to a computer, website or other network devices, in order to successfully differentiate them from one another in an active network system.
In Computer Networking, a command which an administrator (end user) would use to perform a reverse lookup of the IP address 10.0.0.3 on a Linux system is dig -x 10.0.0.3.
Read more on Linux commands here: brainly.com/question/25480553
#SPJ1
Clear out unnecessary files, for example caches, caches are a collection of items of the same type stored in a hidden or inaccessible place.
If the meter is set to read DC voltage in the 20 volt range and it displays a 1 then it should mean 1 volt assuming that the maximum reading would be 20 volts at that setting. But if it is only around 1 volt is might be more accurate to set it at say 2V range to get say 1.6 actual volts.