Answer:
theoretically yes. we would need to cross and langue gap because our brain signals wouldn't understand words
Explanation:
educated quess
I think it’s number 1. Check the answer first.
The first commercially-available USB flash drive was the "ThumbDrive," produced by Singapore company Trek Technology in 2000. The drive had capacities of
8 MB
64 MB
1.44 MB
256 MB
Answer:
A) Map
Explanation:
All gasoline (petrol) fuel systems need ways or method that will be calculating amount of the air that is entering the engine.This is true as regards mechanical fuel injection, carburetors and electronic fuel injection.Speed density system fall under one of this method. "Speed" in this context means the speed of the engine while "density" means density of the air. The Speed is been measured using the distributor, crankshaft position sensor could be used here. The Density emerge from from measuring of the air pressure which is inside the induction system, using a typical "manifold absolute pressure" (MAP) sensor as well as air temperature sensor. Using pieces of information above, we can calculate
mass flow rate of air entering the engine as well as the correct amount of fuel can be supplied. With this system,
the mass of air can be calculated. One of the drawback if this system is that
Any modification will result to incorrect calculations. Speed-Density can be regarded as method use in estimation of airflow into an engine so that appropriate amount of fuel can be supplied as well as. adequate spark timing. The logic behind Speed-Density is to give prediction of the amount of air ingested by an engine accurately during the induction stroke. Then this information could now be used in calculating how much fuel is required to be provided, This information as well can be used in determining appropriate amount of ignition advance. It should be noted The speed density fuel injection system uses the Map sensor as the primary sensor to determine base pulse width
Answer:
x = int(input("Enter an integer: "))
y = int(input("Enter another integer: "))
if x > y:
for number in range(y+1, x):
print(number, end=" ")
elif y > x:
for number in range(x+1, y):
print(number, end=" ")
else:
print("There are no integers between {} and {}".format(x, y))
Explanation:
*The code is in Python.
Ask the user to enter the two integers, x and y
Since we want our program to run regardless of which entered value is larger, we need to compare the numbers to be able to create the loop that prints the numbers.
Check if x is greater than y. If it is, create a for loop that iterates from y+1 to x-1 and print the numbers
Otherwise, check if y is greater than x. If it is, create a for loop that iterates from x+1 to y-1 and print the numbers
If none of the previous part is executed, print that there are no integers between
