A. (pie chart) - correct answer
Answer:
ok, no because this site is for hw
Explanation:
Answer: packets
Explanation:
Network navigation devices, such as routers, help data travel in bundles that are referred to as packets. As, networks that transfer the data in small packets are known as packet switching network and that packets carry the data using the internet and the protocol and each of the packet contain some information and data to navigate.
Depends on how deep you're willing to go to really,
You need one of a few arrangements of flip flop circuits to keep 1-bit state.
Going deeper, you need either NAND, or NOR gates(or a bunch of other ones) and connectors.
Even deeper, you'll require diodes or transistors to build the logic gates.
Beyond that is particle physics.
Answer:
The solution code is written in Python 3:
- def modifyList(listNumber):
- posCount = 0
- negCount = 0
-
- for x in listNumber:
- if x > 0:
- posCount += 1
- else:
- negCount += 1
-
- if(posCount == len(listNumber)):
- listNumber.append(max(listNumber))
-
- if(negCount == len(listNumber)):
- listNumber.append(min(listNumber))
-
- print(listNumber)
-
- modifyList([-1,-99,-81])
- modifyList([1,99,8])
- modifyList([-1,99,-81])
Explanation:
The key step to solve this problem is to define two variables, posCount and negCount, to track the number of positive value and negative value from the input list (Line 2 - 3).
To track the posCount and negCount, we can traverse through the for-loop and create if else statement to check if the current number x is bigger than 0 then increment posCount by 1 otherwise increment negCount (Line 5- 9).
If all number in the list are positive, the posCount should be equal to the length of the input list and the same rule is applied to negCount. If one of them happens, the listNumber will append either the maximum number (Line 11 -12) or append the minimum number (Line 14-15).
If both posCount and negCount are not equal to the list length, the block of code Line 11 -15 will be skipped.
At last we can print the listNumber (Line 17).
If we test our function using the three sets of input list, we shall get the following results:
[-1, -99, -81, -99]
[1, 99, 8, 99]
[-1, 99, -81]
