Answer: Provided in the explanation section
Explanation:
The question to this problem says;
Question:
I am sorting data that is stored over a network connection. Based on the properties of that connection, it is extremely expensive to "swap" two elements. But looping over the elements and looking at their values is very inexpensive. I want to minimize swaps above all other factors. Choose the sorting algorithm we studied that will perform the best:
ANSWER
1. Merge Sort
Because merge sort uses additional memory instead of swapping the elements.
2. Merge Sort and Quick Sort both can be used with multi processor.
cheers i hope this helps !!!
Answer: A. Multicast
Explanation:
Here we are given a situation where it is necessary for the device to stream media to all the PCs connected across the LAN. But as the they are unable to stream the media then it is a problem in the multicast TCP/Ip technology.
Multicasting enables to transfer information or messages from one to many or many to many. Here as a single device is responsible for streaming the content to other PCs across the LAN, therefore it is necessary that multicast has been properly implemented.
Option B is incorrect as it is not a scenario of broadcast as in broadcasting all the receivers must get the streaming however here if a PC does not want to receive the media stream it cannot receive for which multicasting is required.
Option C is incorrect as here we are not talking of one to one communication.
Option D is incorrect as here we cannot have more than one route to send the media content except the LAN.
1. Spam
2. Phishing
3. True
Answer:
Explanation:
Router. A router is a networking device typically used to interconnect LANs to form a wide area network (WAN) and as such is referred to as a WAN device. IP routers use IP addresses to determine where to forward packets. An IP address is a numeric label assigned to each connected network device.
Fям:- 
Answer: Quick Access Toolbar
The Quick Access Toolbar is located to the right of the Microsoft Office Button . It contains commands that are used most often, for example Redo, Undo and Save.
Explanation:
