There are two general types of collisions, inelastic and elastic.
Inelastic collisions occur when two objects collide but neither of them bounce away from each other.
Collisions in which the objects do not touch each other are elastic. (Ex: Rutherford Scattering)
It’s either B or A, I hope this helps! I tried!
If you are trying to loosen a stubborn bolt from a piece of metal with a wrench and fail, should you find a wrench for which the handle is: longer.
<h3>What is angular acceleration?</h3>
- The temporal rate at which angular velocity changes is known as angular acceleration. The standard unit of measurement is radians per second per second. Therefore, = d d t. Rotational acceleration is another name for angular acceleration.
- Angular velocity divided by acceleration time can be used to define angular acceleration. (t). As an alternative, use pi times the drive speed (n) divided by the acceleration time (t) times 30. Radians per second squared (Rad/sec2) is the standard SI unit for rotational acceleration resulting from this equation.
- To calculate angular velocity, we can use one of three formulas. The definition itself provides the first. Theta = position angle, t = time, and w = angular velocity, where w = angular velocity, theta = position angle, and t = time. Angular velocity is the rate of change of an object's position angle with respect to time.
- The symbol for angular acceleration is, and it is measured in rad/s2, or radians per second square.
If you are trying to loosen a stubborn bolt from a piece of metal with a wrench and fail, should you find a wrench for which the handle is: longer.
To learn more about angular acceleration, refer to:
brainly.com/question/20912191
#SPJ4
Answer:
Remember that as the temperature of an object increases, the kinetic energy of the particles inside it also increases.
So, if the temperature of a wire increases, the kinetic energy of the particles inside increases. Then when the electrons try to flow through the wire, the probability of a collision is increased (then the resistance increases). Thus, if the filament goes from red-hot to white-hot (so the temperature of the wire increases) we can conclude that the resistance that the current experiences also increases.
So no, we can not expect the resistance of the light bulb to remain constant as the filament goes from red-hot to white-hot.
