Answer:
The calculated concentration of sodium thiosulphate solution will be less than the actual value.
Explanation:
When IO3^2- solution is added to KI solution, I2 gas is released ,then sulphuric acid is now added to facilitate reduction. In order to prevent the escape of iodine (I2) gas ,the solution must immediately be titrated with thiosulphate.
If the solution is not immediately titrated with thiosulphate, the concentration of iodine available in the system decreases. When this occurs, it will also cause a decrease in the amount of iodine available to react with thiosulphate thus decreasing the concentration of thiosulphate obtained from calculation
Answer:
20.93 g
Explanation:
From the question given above, the following data were obtained:
Heat (Q) = 3.5 KJ
Initial temperature (T₁) = 26°C
Final temperature (T₂) = 66°C
Mass (M) =?
Next, we shall convert 3.5 KJ to J. This can be obtained as follow:
1 KJ = 1000 J
Therefore,
3.5 KJ = 3.5 KJ × 1000 J / 1 KJ
3.5 KJ = 3500 J
Next, we shall determine the change in the temperature of the water. This is illustrated:
Initial temperature (T₁) = 26°C
Final temperature (T₂) = 66°C
Change in temperature (ΔT) =?
ΔT = T₂ – T₁
ΔT = 66 – 26
ΔT = 40 °C
Finally, we shall determine the mass of the water. This can be obtained as follow:
Heat (Q) = 3500 J
Change in temperature (ΔT) = 40 °C
Specific heat capacity (C) = 4.18 J/gºC
Mass (M) =?
Q = MCΔT
3500 = M × 4.18 × 40
3500 = M × 167.2
Divide both side by 167.2
M = 3500 / 167.2
M = 20.93 g
Therefore, the mass of the water is 20.93 g
When a cold air mass meets a warm air mass, a front is formed; if the cold air is replacing the warm air, it is known as a cold front. Cold fronts frequently cause rain showers or thunderstorms because they force air in a steep upward direction at the front's edge. They also bring about changes in wind direction and atmospheric pressure.
<span> </span>