Answer:
All the ports in a hub are in the same collision domain and a hub sends frames from one host to all other hosts in the network. This makes it prone to collision and poor network throughput. Just like a network switch, it uses the CSMA/CD protocol to detect collision in its network.
A network switch reduces its collision domain to just a port and sends frames from one host to another using its mac table as a route. This makes the network very efficient with high throughput. It also uses the CSMA/CD protocol to detect collision
Explanation:
Switches and hubs are used in networking to connect computer devices in a network. A hub is an obsolete device networking that broadcast a frame to all other ports or host in the network except for the send host port. This increases the rate of collision as all the ports in a hub share the same collision domain. A switch is an efficient frame switching device in a network, which uses its MAC table to decide and find a destination host.
CSMA/CD is a collision detection protocol used in a network to detect and prevent a collision. With this protocol, a host is able to listen, wait, send and resend frames to prevent a collision.
The Lucent connector(LC) is a type of fiber optic connector used here.
Explanation:
A Lucent connector (LC) is a type of fiber optic connector connects to a terminating device by pushing the connector into the terminating device and can be removed by depressing the tab on the connector and pulling it out of the terminating device.
It is a standard ceramic Ferrule connector and has good performance and is favored for single mode.
LC is a latched connector which have same handling capacities like SC. They have small flange on top similar to an RJ-45 connector that aids secure connection. It has a smaller connector housing and a smaller 1.25 mm ferrule.
A sail boat went to a row boat.
The thing that happens if you type a number instead of a word in the given code is: The number is printed
This is because the code already assigned a variable to the input and it accepts both numbers and alphanumeric keys because it is an integer command.
<h3>What is Coding?</h3>
This refers to the use of programming that is used to give instructions to a computer system
Hence, we can see that The thing that happens if you type a number instead of a word in the given code is: The number is printed
This is because the code already assigned a variable to the input and it accepts both numbers and alphanumeric keys because it is an integer command.
Read more about coding here:
brainly.com/question/16397886
#SPJ1
Answer:
Answer provided in screenshot, not really too happy with my implementation but it works.
Explanation:
Iterate through months, handling logic for every 12 months to get the raise.
