Answer:
The number of routers arrived in the path of a packet from sender to receiver are called hops. It is term used usually in computer networking.
<u>Command Used to find Hops</u>
In windows command prompt is used to find the number of hops.
1. In Command Prompt type "<em>tracert</em>" after host name and IP address of destination.
<u>Hardware devices Represented by Hop</u>
The main devices that is counted as hop in networking is <em>Router</em>. Nut Sometimes many devices such as <em>switches, repeaters and access points</em> are also count as hops. It depends on the configuration and role of the devices.
Answer:
1. Place your cursor in the General Provisions section towards the finish of the archive.
2. On the Page Layout tab, in the Paragraph gathering, tap the Paragraph Dialog Box Launcher and afterward tap the Line and Paragraph Breaks tab.
3. Select the Keep lines together checkbox and snap Ok.
Explanation:
In a short report or one that doesn't require a complex navigational structure, you can without much of a stretch configuration words and sections so key focuses emerge and the structure of your record is clear. You can accomplish sensational by applying predefined Word Art content impacts. To keep the presence of reports and other Microsoft Office records steady, you can organize archive components by applying predefined sets of designing called styles. Moreover, you can change the textual styles, hues, and impacts all through a record with a single tick by applying a subject.
Answer:
There is also an attachment below
Explanation:
Since we are talking about binary search, let's assume that the items are sorted according to some criteria.
Time complexity of binary search is O(logN) in worst case, best case and average case as well. That means it can search for an item in Log N time where N is size of the input. Here problem talks about the item not getting found. So, this is a worst case scenario. Even in this case, binary search runs in O(logN) time.
N = 700000000.
So, number of comparisions can be log(N) = 29.3 = 29.
So, in the worst case it does comparisions 29 times
Answer:
Check the explanation
Explanation:
A packet filter firewall is used as a check point between internal corporate network to the outside internet. It blocks all the inbound traffic from the outside hosts trying to initiate a direct TCP connection to the internal corporate webserver. The network design with firewall is shown in the attached image below:
The figures in the attached image below shows an internal corporate network is protected with a packet filter firewall to minimize the inbound traffic from the external network or an internet. Therefore, the packet filter is used as a check point between the network.
The packet filter blocks all attempts by the outside hosts in order to initiate a direct TCP connection to the internal webserver of the internal corporate network.
Going by the second part of the attached image below can can therefore conclude that:
• Rule 1 specifies that, deny any packet with the destination address 5.6.7.8 if the STN flag of TCP header is set.
• Rule 2 specifies that, allow the inbound email traffic from the external source.
• Rule 3 specifies, allows the Outbound TCP traffic from the internal corporate network.
• Rule 4 specifies, allows outbound Email traffic from the internal corporate network to the external network.
• Rule 5 specifies, block any traffic from any source to the any destination.
Answer:
suppose i was i would tell them i dont know and walk away
Explanation:
in thoery this is correct
you said suppose so i answerd
there is no use in reporting or getting this taken down
nether is it right
im not stealing points
Because in thoery its an answer
<em><u>THIS IS MY PROTEST</u></em>