Answer:
LDPE would be the best choice for a hand warmer designed to release heat quickly.
Explanation:
Judging from the graph, the LDPE plastic releases heat quicker than the Latex. (and I also did the gizmo-)
Refer to the diagram shown below.
The piston supports the same load W at both temperatures.
The ideal gas law is
where
p = pressure
V = volume
n = moles
T = temperature
R = gas constant
State 1:
T₁ = 20 C = 20+273 = 293 K
d₁ = 25 cm piston diameter
State 2:
T₂ = 150 C = 423 K
d₂ = piston diameter
Because V, n, and R remain the same between the two temperatures, therefore
If the supported load is W kg, then
Similarly,
Because p₁/p₂ = T₁/T₂, therefore
The minimum piston diameter at 150 C is 20.8 cm.
Answer: 20.8 cm diameter
The crystal structure of barium fluoride BaF₂ and magnesium fluoride MgF₂ is cubic and tetragonal lattice respectively.
There are difference between the cubic and tetragonal lattice of any crystal. For cubic lattice a = b = c and α = β = γ = 90⁰ and for tetragonal lattice a = b ≠ c and α = β = γ = 90⁰ (where a, b and c are the edge length of the lattice and α, β, γ angle of the crystal lattice).
The difference of the structure depends on the size of the ions present in the compound. In BaF₂, the ions are Ba²⁺ and F⁻. In MgF₂, the ions are Mg²⁺ and F⁻.
Although the size of the anion in both the crystal is same, there is a huge difference between the size of the cation, which affect the crystal lattice of the compound.
Answer:
The freezing point depression ∆T = KF·m where KF is the molal freezing point depression constant and m is the molality of the solute. Rearrangement gives: mol solute = (m) x (kg solvent) where kg of solvent is the mass of the solvent (lauric acid) in the mixture. This gives the moles of the solute.
Explanation:
Does this help at all??
Answer: 273.15
Explanation: BEng smart lol