Answer:
Slope =
y-intercept = 2
Equation of the line 't':
Step-by-step explanation:
Slope of a line passing through two points and is represented by,
Slope 'm' =
Since line 't' is passing through two points (0, 2) and (8, -4),
Slope of the line 't' =
m =
m =
Since y-intercept of a line is the value of 'y' for x = 0 [from point (0, 2) lying on this line]
Therefore, Y-intercept of line 't' = 2
Slope intercept of an equation is,
y = mx + b
where m = slope of the line
b = y-intercept
Therefore, equation of the line 't' will be,
Answer:
We have the equation:
(14 N/mm)*X = Y N/cm
So we want to transform 1/mm to 1/cm.
We know that:
10mm = 1cm
1 = 10mm/1cm (we want to have mm on the numerator, so it cancelates with the mm in the denominator)
then the conversion is from 1/mm to 1/cm is:
X = 10mm/cm
then we have:
(14N/mm)*(10mm/cm) = 140 N/cm
Answer:
- Line XY contains ray OX and ray OY
- Line XY contains segment YX
- Ray YX exists in the diagram
Step-by-step explanation:
A ray can be named by any pair of points on an infinite line. Point O, X, and Y on the same line can be used to name rays OX, OY, XY, YX, OY, and XO. The first point named is the end point of the ray. The ray goes through the other point and continues indefinitely.
BA can be the name of a line segment, but not a ray. The line shown does not extend from point B beyond point A.
Any segment can be named by its end points in either order.
So, we have ...
- Line XY contains ray OX and ray OY
- Line XY contains segment YX
- Ray YX exists in the diagram
A) get rid of the fraction by finding the common denominator, 4. multiplying by 4 on both sides, I usually have it turned into a fraction, 4/1. The 2x=3/4, is now 8x=12/4 will be set as 8x=3. Divide 8, x=3/8.
B) The common denominator is 15. Multiply on both sides, -2/5 times 15/1 is -30/5 which becomes -6. And m/3 times 15/1 is 15m/3, 5m. divide the 5 and your answer is m=-5/6
Answer: "...in descending order."
There you go.