Answer: part 1
1. You need a Source of electric power (battery or generator), a load to absorb the power (lamp, motor, heating coil) and wiring to connect the load to the power source!
2. they both give off electricity energy, and they are different because they dont release the same amount of energy
3. Current will increase
Explanation:
In Ohm's law the equation for current is current = voltage / resistance.
In order to explain how current is effected when resistance decreases while voltage stays the same, lets represents the situations with some possible inputs.
Let's compare 3 different closed circuits all with a voltage of 10V.
In circuit 1, the resistance is 5 ohm.
In circuit 2, the resistance is 2 ohms.
In circuit 3, the resistance is 1 ohms.
The current of:
Circuit 1 = Voltage / Resistance = 10 V / 5 ohms = 2 Amps
Circuit 2 = Voltage / Resistance = 10V / 2 ohms = 5 Amps
Circuit 3 = Voltage / Resistance = 10V / 1ohm = 10 Amps
As you can see in this representation, as the resistance in a circuit increases while the voltage is constant, the total current is increased.
4. The resistance of a conductor is the ratio of the voltage
between its ends to the current through it.
If the voltage between the ends of a light bulb's filament
increases but the filament's resistance remains constant,
then the current through it increases by the same factor
as the voltage increase. The effect is to cause the light
to emit more light and heat ... both increase proportional
to the square of the voltage ... and possibly to "burn out".
Part 2
1. it's a circuit wherein all the elements are in parallel and a resistance is fitted in series across which a voltmeter is connected to measure potential drop acrossR so as to find the current across the load that is bulb which connected to in series with the resistor
2. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
3. The switch simply opens (off) or closes (on) the connection between the two terminals on the switch. When the switch is on, current flows along the black wire through the switch to the light, and then returns to ground through the white wire to complete the circuit.
4. the current runs through the motherboard and into the smaller components or the small internal wiring
5. A battery is made up of three parts. The Cathode (positive end +) , the Anode (negative end -) and the electrolyte. The electrolyte allows electrical charges to travel between the cathode and anode. This chemical reactions creates the flow of electricity supplying the electrical voltage potential to power a circuit.
Typical materials of a battery are as follows
- Anode most often is made of zinc
- Manganese dioxide acting as Cathode.
- the electrolyte between and inside contains ions
Hope this help
r²