Answer:
If A and B are two rational numbers such that A<B
Then X = A + (B-A)/π would be an example of an irrational number
such that A < X < B
Hope this helps
Please give me brainliest
Answer:
0
Step-by-step explanation:
The answer would be 0
Answer:
6
Step-by-step explanation:
Richard gets 7 more sweets than Gavin which would probably make Richard have the most so in total he should have around 8 whilst Gavin has 1 so right now we have 4:1:?. Basing off the fact that Richard would have the most sweets Henry would have to have 6 sweets to be able to divide half of it for 3. 4:1:3
Approximately 1700 megawatts of electricity could be supplied by Hydropower in 2017. Option B is correct.
Given that,
In 2017 there were enough renewable energy sources to supply a total of 9309 megawatts of electricity in a country. The graph shows the proportions that the different renewable energy sources could supply.
<h3>What are percentages?</h3>
the percentage is the ratio of the composition of matter to the overall composition of matter multiplied by 100.
Here, from the graph contribution of the hydropower is 18.2%.
So the electricity produced through hydropower is,
= 9309 * 18.2%
= 9309 * 18.2/100
= 1694.23
≈ 1700 megawatts
Thus, approximately 1700 megawatts of electricity could be supplied by Hydropower in 2017.
Learn more about percentages here:
brainly.com/question/13450942
#SPJ1
Answer:
just do the step by step and you'll probably get it because it's quite simple but hard for me to explain so just read this!
Step-by-step explanation:
In making any measurement, the chances are that our results will not be absolutely accurate. We can often compare our results with some standard or accepted value to see how closely they agree. But how much error can be allowed before the result becomes meaningless?
As you may guess, the amount of error that is acceptable varies with the situation. Suppose you measure the distance on a map between your Scarsdale and Mamaroneck and you get a result of 5 miles. If the actual distance is 5 1/2 miles, the chances are this error will have no effect on the trip between the two towns. But if the same degree of error existed in the calculations used to send astronauts to the moon, those people would be in big trouble!
Percentage Error = <u>measured value - accepted value</u> x 100%
accepted value
Suppose, you measured the length of a table and obtained a measurement of 202 cm. A friend also measures the table and obtains a result of 198 cm. To calculate the percentage error in each of the measurements, you need to know the "correct' or “accepted value” of the length of the table. After consulting the manufacturer’s catalog, you find that the table's length is listed as 200 cm in length. This will be used as the accepted value in our calculation.
The calculations of percentage error for the two measurements are shown below. Both measurements show an error of 1%. Your friend has made a measurement which is on the low side of the accepted value and is therefore, negative. You, on the other hand, have made an error on the high side of the accepted value and it is positive.
I dont know the answer but I hope this helped!
(sorry for the inconvenience)