In the bank vault researve and at a Federal Reserve Bank
Answer:
Walker's did not outperform because it PE Ratio is close to Industry average. Industry's data is based on average which means some of the firms may have very high PE ratio and some might have quite lower than the average. It is not obvious that the Walker's outperformed or under-performed. Complete data about the individual firms might make us able to compare the performance of Walker's. Apparently its performance is up to the mark as its PE ratio is very close to Industry average.
Explanation:
<u>PE Ratio</u> is a term which show the investors confidence on the firm. It shows that how much price investors are willing to pay against each unit of earning.
Answer:
b, c and a
Explanation:
Ability to pay principle refers to an economic principle that states that the amount of tax an individual pays should be <u>dependent on the level of burden the tax will create relative to the wealth</u> of the individual.
Based on the above definition, the first category will be:
1. Local property taxes support elementary and secondary schools. <em>This tax will definitely generate the biggest tax burden of the 3 cases in the scenario.</em>
2. An airport trust fund collects a tax on each plane ticket sold and uses the money to improve airports and the air traffic control system. <em>Obviously this tax will be of a higher burden than paying national park entrance fees but will not be as heavy as local property taxes</em>
3. Visitors to many national parks pay an entrance fee. <em>Park entrance fees will be of the lightest burden of the three cases in the scenario.</em>
<em />
Answer:
a. under applied.
Explanation:
For computing, whether it is under applied or over applied first, we have to compute the predetermined overhead rate. The formula is shown below:
Predetermined overhead rate = (Total estimated manufacturing overhead) ÷ (estimated direct labor-hours)
Now we have to find the applied overhead which equal to
= Actual direct labor-hours × predetermined overhead rate
So, the ending overhead equals to
= Actual manufacturing overhead - applied overhead
= under-applied
If actual overhead is more than the applied overhead
