Answer:
B)
Step-by-step explanation:
In statistics, an outlier is a data point that differs significantly from other observations.
This can happen because of different reasons: it may be due to variability in the measurement or it may indicate an actual experimental error. If it is an actual experimental error then it can create problems when doing the statistical analysis.
A) We can say that this is true, the outliers are observed values far from the other data, however we can make a much deeper analysis of this.
B) This is the right answer, since we don't know what is really causing the outlier, we need to take a closer look to see if they are just mistakes (and therefore be removed). If they are not mistakes we need to do the analysis with and without them to reach correct conclusions.
C) this is wrong because although the part of the histogram is true. It is not true that they should be ignored.
d) The outliers differ significantly from the other data but this doesn't make them the minimum and maximum values in a data set and therefore they should not be treated as such.
Therefore, the correct answer is B)
Answer:
Slope =-1/3
Step-by-step explanation:
(3,2)..... x1 =3, y1=2
(-3,4).... x2=-3, y2 =4
Slope=(y2-y1) /(x2-x1)
Slope=(4-2) /(-3-3)
Slope =2/(-6)
Slope=-1/3
Volume of a cube is length * width * height. Because it's a cube, all of these lengths are the same measurement so rather than doing V = l*w*h, we can do one of the measurements cubed, let's call it x.
So Volume = x³. So if we are given the volume, we can the length by doing the cube root.
∛125 = 5
∛216 = 6
Surface area of a cube = 6x². So now we plug both of these measurements into the formula.
For 5:
SA = 6(5)² = 6(25) = 150
For 6:
SA = 6(6)² = 6(36) = 216
The ratio of their surface areas is 150:216 or if you simplify it by dividing both by the GCF of 6, 25:36
Answer:
19.504
Step-by-step explanation:
divide the mass value by 2.205
The answer would be A. -18x^7
hope this helps:)
