Answer:
1.) 25 ; 15 ; 15
2.) 50 ; 15 ; 50
Explanation:
In the first function written :
The variable val was initially decaled or assigned a value of 25 and that was what was printed first.
However, after the example function was written, the val variable was finally assiagned a value of 15 within the function. However, it was also declared that the global variable takes uonthe val value. Hence, the val variable initially assigned a value, of 25 changes to 15 globally.
For the second code :
From the top:
Val was assigned a value of 50 ;
Hence,
print(val) gives an output of 50
Within the function definition which prints the value of val that is assigned a value of 25 within the function.
Since tbe global variable isnt reset.
Printing Val again outputs 50;since ito is outside the function.
Answer:
hope you like it
Explanation:
Two types of power supplies exist, DC-DC and AC-DC. DC-DC power supplies allow you to plug in electrical devices into car outlets or similar sources that supply direct current, or DC, power. These power supplies are not the most commonly used, though.
Classification of Power Supply and Its Different Types
OUTPUT = DC OUTPUT = AC
INPUT = AC Wall wart Bench power supplies Battery charger Isolation transformer Variable AC supply Frequency changer
INPUT = DC DC-DC converter Inverter Generator UPS
Explanation:
The X's have been correctly placed in the chart
A surge suppressor, which is also commonly known as a surge protector, is an important equipment that helps prevent damage to electric components from an unexpected increase of voltage. Let’s assume that you are living in a county where the effective utility voltage is between 110 to 120 volts. Assume that the accepted peak voltage should not be anything higher than 170 volts. If there is a surge and this surge reaches peak levels of 170 volts and higher, surge suppressors should jump in and prevent the peak AC voltage from going above the threshold.
People tend to confuse line conditioners and surge suppressors. While surge suppressors protect components from surges, line conditioners are built to make up for the loss of voltage from the lines. It does so by storing some power energy. This stored energy can later be modified and used when the volts drops to the desired 110 volts.
A UPS has DC battery power that provides battery backup power when the electricity goes off or when the levels of voltage drop significantly. When the electricity goes off means that the voltage is at 0 volts and it is the work of the UPS to kick its backup power in.
Answer:
Code is in the attached screenshot.
Explanation:
Assumed it was written in Java based on your other question asked.
