I think the glycolysis occurs in the cytosol.
You didn’t show the models but Prokaryotes are unicellular organisms that lack organelles or other internal membrane-bound structures. Here is a picture. I hope it helps
Answer:
Dessert and tundra
Explanation:
Theses two biomes get very little rain and because of this they have a less diversity of fauna and flora.
The differences are that a tundra is very dry and extremely cold and on the other hand a desert is very arid and hot and it can go as high as 54°C (130°F).
1. The virus attaches itself to a host cell
2. The virus inserts its nucleic acid into the host cell
3. The virus nucleic takes over the host cell and makes virus parts
4. The cell creates more viruses
5. The cell bursts, releasing the new viruses
Explanation:
Wind energy, or wind power, is created using a wind turbine, a device that channels the power of the wind to generate electricity. The wind blows the blades of the turbine, which are attached to a rotor. The rotor then spins a generator to create electricity . Wind energy is a renewable energy source that is clean and has very few environmental challenges. Wind power actually starts with the Sun. In order for the wind to blow, the Sun first heats up a section of land along with the air above it. That hot air rises since a given volume of hot air is lighter than the same volume of cold air. Cooler air then rushes in to fill the void left by that hot air and voila: a gust of wind. The Office of Energy Efficiency and Renewable Energy describes a wind turbine as “the opposite of a fan.” Simply stated, the turbine takes the energy in that wind and converts it into electricity. So how does it do that? First, the wind applies pressure on the long slender blades, usually 2 or 3 of them, causing them to spin, much like the wind pushes a sailboat along its path through the water. The spinning blades then cause the rotor, or the conical cap on the turbine, and an internal shaft to spin as well at somewhere around 30 – 60 revolutions per minute. The ultimate goal is to spin an assembly of magnets in a generator which will, well, generate voltage in a coil of wire thanks to electromagnetic induction. Generators require faster revolutions, however, so a gear box typically connects this lower speed shaft to a higher speed shaft by increasing the spin rate to around 1000 to 1800 revolutions per minute. These gear boxes are costly as well as heavy, so engineers are looking to design more “direct-drive” generators that can work at the lower speeds.