1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Leviafan [203]
3 years ago
8

A customer complains that the car pulls to the left during hard braking. An inspection shows that the front pads and rear shoes

are worn. After resurfacing the rotors and drums and replacing the pads and shoes, a road test reveals that the car still pulls to the left during hard braking. Technician A says the wheel alignment should be checked. Technician B says the tires could be the problem and should be swapped left to right to check whether the direction of the pull changes. Who is correct
Engineering
1 answer:
dezoksy [38]3 years ago
5 0
Technician B I did this in my lesson and the right answer is B
You might be interested in
a motor has torque of 200 nm if i motors attached to an arm with a length of 25 cm and a string is too attached to the end appro
kogti [31]

Answer:

noescompa

Explanation:

puntos

8 0
3 years ago
Which utility program reads an assembly language source file and produces an object file?
iragen [17]

Answer:

Assembler

Explanation:

An assembler can be define as a computer utility program that read, interpret and convert software programs written in low level assembly language into an object file, machine language, code and instruction that can be understood and executed by a computer.

5 0
3 years ago
Although studs are sometimes spaced 24" O.C. in residential structures, a spacing of_____ O.C. is more commonly used.
Allisa [31]

Answer:

B. 16

Explanation:

hope this helps

 - Leila

4 0
2 years ago
A cylindrical specimen of a metal alloy 45.8 mm long and 9.72 mm in diameter is stressed in tension. A true stress of 378 MPa ca
Sliva [168]

Answer:

390.242 MPa

Explanation:

Attached is the full solution.

8 0
3 years ago
Yes I’m very cool I promise.
Alex
Okay I believe you I swear
8 0
3 years ago
Other questions:
  • Which term defines the amount of mechanical work an engine can do per unit of heat energy it uses?
    5·1 answer
  • Consider a fully developed laminar flow in a circular pipe. The velocity at R/2 (midway between the wall surface and the centerl
    6·1 answer
  • A flow of 12 m/s passes through a 6 m wide, 2 m deep rectangular channel with a bed slope of 0. 001. If the mean velocity of flo
    12·1 answer
  • How can you drop two eggs the feweHow can you drop two eggs the fewest amount of times, without them breaking? ...st amount of t
    13·2 answers
  • Set the leak rate to zero and choose a non-zero value for the proportional feedback gain.Restart the simulation and turn on the
    5·1 answer
  • What happens to the electrolyte, during discharging?
    9·1 answer
  • Think about a good game story that made you feel a mix of positive and negative emotions. What was the story, what emotions did
    13·1 answer
  • Explain how to properly engage the safety latches on the Stan Design Pit Jack.
    10·1 answer
  • What is the difference between absorbed wavelengths and reflected wavelengths?
    11·1 answer
  • Which thematic group is involved in the transmission and generation of electrical power?
    10·2 answers
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!