<u>Throughput </u> is the actual speed of data transfer that is achieved between two nodes on a network and is always less than or equal to the data transfer rate.
<h3>What is used to transfer data packets between two or more networks?</h3>
A router is a networking device that forwards data packets between computer networks. Routers perform the traffic directing functions on the Internet.
<h3>What is throughput in data transfer?</h3>
In data transmission, network throughput is the amount of data moved successfully from one place to another in a given time period, and typically measured in bits per second (bps), as in megabits per second (Mbps) or gigabits per second (Gbps).
To learn more about Throughput , refer
brainly.com/question/25302150
#SPJ4
Answer:Analog component signals are comprised of three signals, analog R′G′B′ or YPbPr. Referred to as 480i (since there are typically 480 active scan lines per frame and they are interlaced), the frame rate is usually 29.97 Hz (30/1.001) for compatibility with (M) NTSC timing.
Explanation:
Answer:
D. smart phone
explanation;
a. what the heck is a radio going to do?
b. an HD television? is his job watching movies?
d. he already has a form of communication he uses, he needs something that can to both things at the same time
c. a smart phone can do everything he needs to do, likely faster than a landline phone or laptop.
Answer:
Explanation:
yes
but dont forget to call makeBasePlateGreen
maybe you would call it at the end of the program?
by the way you have a typo at the end
make the O lowercase
myBlasePlate.BrickColor = BrickColor.Green()
and then add this to the end
makeBasePlateGreen()
so you call the function and actually use it.
I would say A because it was talking about something in the present but what they were talking about was in past. so I would think A
